Exercise & Fitness - Page 8 - Recent Questions, Troubleshooting & Support
Calibrate incline on Tjojan tr500 treadmill
Method 1: Press Stop and Speed Up, Insert the Key
To calibrate the incline, press and hold the stop and speed increase buttons. While holding the buttons, insert the safety key. The machine will now be in calibration mode. Press the Stop button once. Then, press one of the incline buttons to begin the calibration. It is recommended that you do not stand on the machine while the calibration is taking place.
The machine will move to its highest incline position, then to its lowest decline position. Please wait for the machine to come to a complete stop. When the machine stops moving, the calibration is complete. Remove the safety key from the console to exit calibration mode.
Method 2: Press the Stop Button, Insert the Key
To calibrate the incline, press and hold the stop button. While holding the button, insert the safety key into the console. The machine will now be in calibration mode. Press the stop button once. Then, press either the incline up or incline down button to begin the calibration. It is recommended that you do not stand on the machine while the calibration is taking place.
The machine will move to its highest incline position, then to its lowest decline position. Please wait for the machine to come to a complete stop. When the machine stops moving, the calibration is complete. Remove the safety key from the console to exit calibration mode.
How do you fit a carbon bush to a Stannah 420 stair lift
Installing a carbon bush on a Stannah 420 stair lift requires some technical knowledge and experience, as it involves working with electrical components. If you are not familiar with stair lift maintenance and repair, it's best to contact a professional technician or Stannah service representative to ensure the proper installation and safety of the carbon bush.
However, if you have the necessary skills and knowledge, follow these general steps to fit a carbon brush to a Stannah 420 stair lift:
- Safety First: Before starting any work, ensure the stair lift is turned off, and the power supply is disconnected to avoid any electrical accidents.
- Access the Motor Compartment: Open the motor compartment of the Stannah 420 stair lift. This is usually located under the seat or at the base of the unit. You may need to remove some screws or panels to access the motor area.
- Locate the Carbon Brushes: The carbon brushes are small, rectangular-shaped components made of carbon and graphite, and they make contact with the motor's armature. Look for the existing carbon brushes, which might have worn down or need replacement.
- Remove the Old Brushes: Carefully detach the old carbon brushes from their holders. This may require gently pulling them out or undoing some clips or screws that secure them in place. Take note of how the old brushes were positioned so you can properly install the new ones.
- Install the New Carbon Brushes: Insert the new carbon brushes into their respective holders and secure them in place as per the manufacturer's instructions. Make sure they are positioned correctly and have good contact with the motor armature.
- Reassemble: Once the new carbon brushes are in place, reassemble the motor compartment by putting back any removed panels or covers and tightening any screws that were undone.
- Test the Stair Lift: Reconnect the power supply and turn on the stair lift. Test the unit to ensure the new carbon brushes are working correctly and that the stair lift operates smoothly.
- Regular Maintenance: Carbon brushes wear down over time, so it's essential to perform regular maintenance and inspections to identify when they need replacement. The frequency of replacement depends on the stair lift's usage and other factors.
Again, if you're unsure about any part of this process or lack experience with stairlift maintenance, it's best to seek professional help to ensure the job is done safely and correctly.
Not finding what you are looking for?