Refrigerators - Recent Questions, Troubleshooting & Support


CALL A LOCAL REPAIR SERVICE , MOST LIKELY IT NEEDS FREON ADDED AND ONLY TECH'S CAN DO IT SORRY

Refrigerators | Answered 3 hours ago


YOU GENTLY SQUEEZE THE PLASTIC TO GET IT OUT OF THE WAY

Maytag... | Answered 3 hours ago


The Igloo 100 series portable icemakers that are sold all over for about $100 have several minor issues. For ADD WATER light, there are 2 main ones. The water SENSOR is located at the top right of the unit. Remove the BACK cover with 6 screws on the bottom. Remove the TOP assy with 4 screws from inside the case. When the TOP is off, facing the unit from front, you see the small silver wire at the back right. Clean it AND the screw visible thru the hole in the plastic at the end of the sensor wire. The screw is the GROUND side of the sensor. This fixes many of the issues. But the SENSOR senses water FLOW, not water LEVEL. If the PUMP is not moving water, the sensor assumes you are OUT of water and turns on the ADD WATER light. The pump apparently burns out easily. Remove the PUMP wire connector from the CONTROL BOARD and check for continuity in the motor. Be sure your multimeter leads actually touch the connectors. The connection end is too small for most meters, so probe from the backside of the connector. If motor is good, check for 12vdc at the board side of the pump connector. Plug in, turn on. Should be 12vdc within 45 seconds. See, the water pump comes on first. When water is moving over the sensor, then the board will turn on the compressor and start freezing.

The other issue with not making ice is the crazy condenser coil is a PULL THROUGH. Air enters the machine through the bottom and exits the side. Should be the other way around, because the condenser coil easily stops up with lint and other debris in the air. This creates a high pressure condition for the compressor that will either shut the unit down or cook the compressor. Clean the entering air side of the coil with a brush and blow compressed air through from the fan side. to clean the inner portions of the coil.

Refrigerators | Answered 9 hours ago


CALL YOUR LOCAL REPAIR SHOP , IT NEEDS FREON ADDED AND YOU CAN NOT DO IT YOURSELF

Samsung... | Answered 3 days ago


Depress the alarm button for 3 seconds.
User Preferences:
• Activate or turn off Super Cool (select models) • Change the temperature display from °F to °C
• Enable or disable audible alarms. • Adjust the light level at which the Dispenser Auto Light will illuminate (when this feature is activated on the ice and water dispenser) (select models)
• Activate the Sabbath Mode To access the User

Preferences menu, press and hold the Door Alarm pad for three seconds. When in the User Preferences mode, a short title for the feature will appear in the Freezer temperature display and the feature status will appear in the Fresh Food display.

Refrigerators | Answered on Dec 08, 2019


What type device is the wine opener? Who makes it? There should be a manual for it.

Refrigerators | Answered on Dec 08, 2019


Sounds like you might be low on freon..or the compressor is going bad..

Refrigerators | Answered on Dec 08, 2019


Hold down "Energy Saving" and "Lighting" buttons simultaneously for 10 seconds (or top left & right buttons). Display panel returns immediately. Or try pressing the power freeze and vacation buttons for about 3 secs and it worked great.

Samsung... | Answered on Dec 07, 2019


WITHOUT ANY TESTING REALLY HARD TO GUESS

Refrigerators | Answered on Dec 07, 2019


I went through this same thing! You probably can't find an eject button because there isn't one on the model that you have. It probably isn't turning because it's just stuck and you have to just have confidence that you're not breaking it and force it to the left - all of a sudden, it will "pop" and turn easily.

Here is a great link to show you the different types of Kitchen Aid refrigerator filters - which kind has an eject button and which doesn't:

http://kitchenaid.custhelp.com/app/answers/detail/a_id/149

I also found a great (and short!) video from Kitchen Aid that really helped me see how to do it. Try this one - I thought it was the best:

http://www.kitchenaid.com/content.jsp?sectionId=852

Finally knowing there wasn't an "eject" button saved me many hours of looking, and the tip about using the handles of the plyers worked great.

It is really discouraging to think you can't just screw out a water filter, but it isn't you. The directions are misleading - they don't match what you're seeing, and it doesn't twist out easily - it has to be forced....and THEN it twists out easily.

Hope this helps. It worked for me when I'd completely given up.

Best of luck!

Eileen

KitchenAid... | Answered on Dec 06, 2019

Not finding what you are looking for?
Refrigerators Logo

173,430 questions posted

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

Brad Brown

Level 3 Expert

18121 Answers

Are you a Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...