Sport & Outdoor - Others - Page 6 - Recent Questions, Troubleshooting & Support
I have a ten peaks tent made by quest want to say it sleeps ten with pole color yellow red and black need directions to put it up
https://www.answers.com/Q/Where_can_you_get_instructions_for_the_ten_peaks_tent_by_quest
Unfortunately, the web site given in the link above is no longer in service, so it may be difficult to find instructions other than those at the link.
Quoting from the link above: '
"Ten Peaks Tent by Quest
1) Lay out the tent flat on the ground, be sure to stretch floor to eliminate slack. Drive a stake into each corner loop, then drive the remaining stakes into the side loops.
2) Install the poles by first separating them by their color code. Yellow poles make up the center section. Red poles make up the right and left sides. Slide the yellow poles through the center pole sleeve. Slide the red roof poles through the right and left pole loops of the tent.
3) Raise the tent. Assemble the yellow upright poles and attach them to the yellow roof poles. Raise the center of the tent to its approximate height, by using the quick clamps on the bottom of the yellow center uprights. Assemble the red left and right support poles, attach the support poles to the roof poles. Place the side support poles on the ground near the side stake loops. Adjust the placement and the height of the poles until the tent stands firm.
Coleman hand rocker pump 2231 - seal is gone. Is there a way to repair? Are these still available?
For others, not the OP from ten years ago:
Search Amazon "JR Products 97025 Chrome Manual Water Faucet" and this might be the same mechanism and parts as your Coleman 2231 pump. I went to my local shop in Calgary (starts with an H and ends with obo's, fixya considers that word to be profanity so I can't use the name H*bo's) and they had them there for $39. I swapped the plunger, cork and cylinder from the new one into my Coleman 2231 and will keep the bits from the new one for possibly the other parts in it.
I need the stringing instructions for a Wilson
You can usually search data bases, like https://klipperusa.com/pages/racquet-stringing-patterns. If you are familiar with stringing terminology. If you have been stringing tennis rackets as long as I have (+20 yrs). You can figure it out without stringing patterns.As for the string pattern found on the Klippermate website.Tension 55 - 65, String length 20'M - 18'C, Pattern 16M X 19C, Skip M Holes 7,9T - 7,9B,Tie off M 6B, Start C 7T, Tie off C 5T - 11B
Lost part for rocket fishing rod
The same thing happened to my kids rods.
A friend suggested a product called Bobber Stopper.
It's basically a small bead and string. I found that the bead would not
reel back in, but if you just tie a piece of sting on the line big enough
so it does not fit through the bobber. It worked for me, so hopefully
this will work for you.
Rocket fishing rod repair instructions
I am sure there is one to download but did not found anything with google...
If search engines are no help, just ask some deep web specialists, e.g. http://manualfox.com - this is a manual search agency and if they don´t find it, it does not exist in the Internet.
Not finding what you are looking for?