Cardiozone Elite Plus HR T treadmill and am getting an error E11
Hello again
Having typed everything below the dotted lines for the last 30 minutes, I found this. It has a magnetic speed sensor on the pulley
https://www.justanswer.com/fitness-equipment/2srkz-just-moved-cardiozone-elite-max-hr-treadmill.html
==============================================
Here is the parts diagram and it shows no speed sensor and all parts are unavailable.
https://www.fitnessrepairparts.com/equipment/Select/7631/CardioZone/CZE-Elite-Plus-HRT
Parts Diagram closeup
https://www.fitnessrepairparts.com/equipment/7631/diagrams/7403
That is contradicted here, but my view is that they are guessing because the parts diagram shows no sensor and if it was there and a part of the management system and expected to fail, it would be. There is a picture of of two sensors from Amazon and eBay, one is a Hall Effect Sensor, and the other is a Magnetic sensor. If it has them, you wouldn't be able to miss them and they would be connected to Part 17 - Controller.
https://www.google.com/search?q=cardiozone+elite+plus+hr+t+treadmill+sensor+replacement
Generic Treadmill Sensors
Treadmill RPM Speed Sensor - Replacement for Pacemaster Bronze, Pro, Plus, Plus 2, Elite, & Select Treadmill
$21.14
Amazon CA
High Quality Treadmill Magnetic Sensor Speed Sensor For Running
$12.89
eBay
Free shipping
..
I need to replace a
1st take side rails off front hood .you have afront roller and a back roller. for the front take out the two or one bolts holding the the roller in placenow the back roller take out the bolts that hold the roller in place . now on the deck there is 3or 4 screwson each side holding the deck in place. slide w/ belt off put on new deck.install screws, rollers ,bolts.. now center w/belt and adjust tention on w/belt
Speed increases dramatically when trying to increase slowly on CardioZone Fast Track Elite II
This could be cused by the the display cover you touch to control the functions pressing on the touch switch array just under it. Carefully remove this. it is held on by adhesive and see if the symptom goes away. If it does, look for any dents on the cover. I have worked with these type of switches for nearly 20 years and they can be problematic. The other possibility is the mechanical switches you use to increase/decrease speed or tilt. They plug in seperately and you can disconnect them to see if they are causing the problem.
12/29/2013 11:28:11 PM •
Cardiozone...
•
Answered
on Dec 29, 2013
E1 error code
This usually means a faulty LCB or motor.The fact it has not been used much doesn't matter. It is 7 years old. Usually you can not see faulty parts on the LCB. I do think if you really want the answer call a treadmill repairer . If you don't know what you are doing it can be dangerous.
Not finding what you are looking for?