Craftsman Drills - Recent Questions, Troubleshooting & Support

look on eBay. my opinion is toss it as the batteries are Ni Cad and have a short life

failing battery --trigger switch fail --damaged wire

charge the battery

https://www.wikihow.com/Test-a-Battery-Charger#:~:text=Touch%20the%20black%20test%20probe%20to%20the%20negative,metal%20prong%20at%20the%20end%20of%20the%20jack. Follow these instructions

Bad Battery...

WWW.SEARSPARTSDIRECT.COM

You can go online with Sears and get the manual via online. You can also contact customer service and they can direct you. Craftman tools have their website you should find something there

I own a Craftsman cordless drill the battery was running somewhat low so I decided to charge it for a little bit I put it back together to use it pushed the trigger and it did not work the light above the trigger started to blink on and off drill did not work please help me what's going on

similar to mine so find out the thread going into the shaft and order either the 3/8 or 1/2 to suit your needs.

Test the batteries with a multimeter that will tell you if the batteries are shot. You can do the same with the charger, test it with a multimeter but I don't recommend it unless you know what you are doing because you will be live testing it.Ryobi belt sander https://toolinspector.com/best-belt-sander/

You can trim down a larger brush,Im not sure what type of brush this uses but you can trim down a brush using a Dremel tool with a diamond wheel where a dusk mask use a set of calipers to get size correct

Battery is non functional. How many years the Battery is old? Try with a new battery. Battery is not charging to full Capacity, if it old one.

no, wire maybe. Sounds like a little housekeeping is in order. motors are a magnet for loose strings.

replace it, the craftsman cordless tools are non repairable.

The craftsman batteries don't last that long before they are bad. I had a craftsman drill driver kit the same as yours and found that you can purchase another tool kit for lees than a battery.

Did you already read your manual for that drill press?if your manual is available there is an instruction on how the drill press work..I think the problem their is the shaft that can be found at the right of the drill press..maybe the error is that the wiring of the shaft.