Daewoo Washing Machines - Page 7 - Answered Questions & Fixed Issues
Water not pump out properly
you have a leaking water supply valve-this can be found right wher you attach the supply hoses-Cheers Denny
Troubleshooting
Best bet would be to unplug the machine, leave it for 30 seconds, then try plugging it back in.
Need service for main bearings repair
I do not recommend any extensive repairs to a washing machine when you can by a new top loader for less than $500. Top loaders may use a little more water, but they give good service for many years.
I have a Daewoo DWD FD1233. It's brand new &
Daewoo e8 - engine error! or Bad soldering. Remove the control panel (the one in which many connections). Remove the rear rubber compound around contacts blue relay. Resolder them. And it will be all ok! Or - remove the entire back of the compound and look for where the bad soldering (cold soldering ). You can see it - blackened or exfoliated. Just solder all.
I have an error code on my dryer. looks like E5
That means that the drum is sticking and you need to make sure that nothing is between the drum and the edges of it OR the control board has failed. See if the drum turns by hand without much effort.
E9 E2 ERROR
Message = E2
Error = OVERFLOW ERROR
Cause & Solution =
The water is supplied continuously due to an defective inlet valve. Change the valve inlet.
The valve inlet is normal, but the water level sensor Change the water level sensor
(sensor pressure) is low. (sensor pressure).
The drain motor does not work - Test and if faulty change the drain pumpMessage = E9
Error = SENSOR PRESSURE ERROR
Cause & Solution = The water level sensor is faulty. Change the water level sensor.
(remove pressure tube and blow through it to make sure it is clear first)
WASHER DOOR STUCK
Not all that uncommon on some front loaders. Yes, it is trying to lock and unlock. You can try two different things that might work. 1) Unplug the unit and let it set for 5 minutes and see if it then unlocks itself. Some units have a bi-metal timing that can take from 2-4 min. to release after the spin stops. 2) Wake up unit by pressing start or any button that starts the lock clicking. Have your hands on the door with some gentle pressure because if it unlocks you can pull the door open. Sometimes these things get mixed up and lock, unlock, and lock again. Once you get it open it usually clears up and does not happen very often.
5/19/2012 10:36:44 PM •
Daewoo...
•
Answered
on May 19, 2012
•
1,336 views
How to clear impellor
Top unscrews, impellor lifts off. Any tangled items can be pulled clear
5/20/2012 10:50:54 AM •
Daewoo...
•
Answered
on May 20, 2012
•
108 views
Black **** in wash
Usually old conditioner. Remove clean and refit dispenser drawer. While the drawer's out, clean inside where it goes. Once refitted, put cycle on hottest wash you can with no powder or conditioner in. In future use less conditioner and put on a hot wash (empty) once a month
Not finding what you are looking for?