Directed Car Audio & Video - Recent Questions, Troubleshooting & Support
The bass knob on my directed (dei) 1100d amp
i need a universal remote bass control and wire for DEI - Directed Audio D24002400W Max, Class D Monoblock Amplifier do you no which 1 will work or where i can get the wire for the bass controller that will work
RECOVERY DAMAGED TALLY DATA
Data Corruption is very rare in Tally, due to its excellent implementation of Binary-Tree Data Structure. Majority of Data Corruption or problems occur only due to Hard Disk fault like Bad Sector, Improper Shutdown or Virus problems. We provide services of Corrupt Tally Data Recovery from the Harddisk, USB Stick, CDs etc. Nearly 100% recovery is possible, depending upon the type of damage done to the media, or the file-system.
RECOVERY DAMAGED TALLY DATA
2005escalade remote starter
did you install a "gm remote start bypass", like DEI model 556L?
if not it is the passlock that is not allowing the car to start.
Directed d2400 turning onnot going on protected mode but sound on the output.needs resetting?
Just turn it on normally then after you verified that the green power light is on. And the protect light is on as well just one by one remove the fuses and then wait one minute not doing anything and just re install the fuses one by one and when the blue directed light reactivates (THE BLUE LIGHT ON TOP OF THE AMP COVER) you are good to go. Sometimes just removeing the amp trigger wire and reinstalling it will do the same thing. hope this helps. i do this on mine every now and again. Just wish i new what caused it to do it in the first place, this is just my solution to get it working again.
Directed 1100 d turns on but no sound
hi there
few steps to try
1) try grounding amp to a new location
(make sure the amp is grounded by itself)
2) check the power wire from the battery to the amp
3) if the 2 steps don't solve the problem try turning your amp settings down and disconnect the power wire from the amp after a few seconds reconnect the power wire and amp should reset itself.........
if this doesn't work let me know there are other tricks that can be done but these are the most common firsts to be tested (also make sure the ground wire is larger than the power wire)
hope this helps
I need help hooking my
Is the sub a single voice coil or dual???? If its a single, just bridge sub to amp....(+ of one channel and the - of the other) amp should show where to bridge with a diagram near speaker outs. If its a dual voice coil, then run one voice coil to the left channel and one voice coil to the right.
Not finding what you are looking for?