Dodge Recent Questions, Troubleshooting Help & Support

google mitchell1 , DIY bingo

A few possibilities: Key FOB Proximity: If the key FOB is near the vehicle, the "Push to Start" screen might stay on. Door Sensor: If the vehicle's door sensor is malfunctioning or if the doors are not properly closed, it could cause the screen to stay on. Battery Issues: If there's an issue with the vehicle's battery or the battery of the key FOB, it could potentially cause this problem. It's also worth noting that some users have reported similar issues with their vehicles and have found success in disregarding the prompts asking to turn off/turn on the car You may have to go to a professional mechanic to get this properly diagnosed. That said, here is the service manual: https://cardiagn.com/dodge-charger-2015-2018-service-manual-wiring-diagrams/

Question edited for clarity. A 'witch' is a lady with a pointy hat that use a broomstick for transport. :>D The distributor will only go on one way that is a small notch in the cap that drops into a notch on the distributor body. Here is the 'firing order', what spark plug wire goes where. https://www.google.com/search?q=1978+dodge+tradesman+v8+firing+order ..

Question edited for clarity. 'Manuel' is the name a Spanish gentleman, a 'manual' is the book you need. There are some good ones in here. https://www.google.com/search?q=1978+Dodge+Tradesmen+manual ..

Fuse and Relay? https://www.google.com/search?q=2013+dodge+charger+a%2Fc+relay+location ..

Question edited for clarity and add some punctuation. Question moved to model category. For strangeness like that, you need an auto electrician with a professional grade scan tool computer to check for diagnostic trouble codes. They can also record what happens after 5 or 10 minutes when the light comes on. Some ideas in the link https://www.google.com/search?q=1997+dodge+3500+charging+light+comes+on+after+10+minutes ..

The ballast resistor in your 1997 Dodge B3500 van is situated under the exhaust manifold, where the engine and transmission connect. ballast resistor ' DodgeTalk Forum

Please don't type in all CAPS, it is considered SHOUTING and is difficult to read, plus you have absolutely no Punctuation! That is not one sentence. No idea when one part end and another starts. The issue is the horn switch itself or the 'clock spring' in the steering wheel. Test and trace the switch and wiring. https://www.google.com/search?q=2007+dodge+caravan+horn+not+working https://www.google.com/search?q=2007+dodge+caravan+clock+spring https://www.google.com/search?q=auto+electrician+near+me ..

The starter relay is found in the underhood fuse panel, located driver's side of the engine bay between the battery and the shock mount.

Joleen, Replacing the sway bar bushings and links is not that difficult. They can be ordered from any auto-parts store, Amazon or eBay. However, you will need to know your rear sway bar diameter before ordering parts. The only way to know this is to measure the rear sway bar diameter. If you're real lucky, the rear bar may have an existing part number tag, but I wouldn't count on it. Replacement procedure can be found on youtube or similar with a Google search. Best regards,

Location of map sensor 98 grand caravan 3.0

I suggest you take this to a TRAINED PROFESSIONAL.

Shock Absorbers are easy to test. Put your hand on the front of the vehicle on each side and press down and up hard and see if the body bounces. It should be hard to press down and come back up slowly and controlled. It could also be the springs, the upper mounting rusted away, worn ball joints, steering tie rod joints or CV Axle universal joints. All those need testing professionally on a lift. It is 32 years old after all. ..

99% chance it is your ignition module.FreeAutoMechanic.com

https://www.justanswer.com/dodge/53nm5-dodge-neon-agjust-throttle-cable.html

Check Fuse 14 Dawn

Dodge Dakota (1996-2000) fuses and relays

Fuse Box Diagrams https://fuse-box.info > dodge > dodge-dakota-1996-20... Fuse box location. The fuse panel is located behind the cover on the driver's side of the dashboard. The location of the fuses in the passenger compartment: ... https://www.google.com/search?q=1996+dodge+dakota+lights+not+working ..

Are you referring to the Auxillary (Fan) belt? These usually have a spring loaded tensioner arm with an idler pulley attached to it. This usually controls the tightness of the belt when the engine is running. They are commonly held on with a single bolt. In most cases if the belt has gone slack this tensioner has failed and will need replacing. You will need to remove the belt before you can do this especially if you want to keep the skin on your knuckles. Yes, I've done that!. It's also worth replacing the belt as well while your in there then you know it's good. **NOTE** Make a drawing or take photos of the route the belt uses BEFORE you take it off.

Auto Parts Stores have books for that spec

Who told you there was a 'power window module'?https://www.google.com/search?q=2017+Dodge+Journey+power+window+Module All things like that are controlled by the BCM (body control module) via switch and regulator. You don't want to be playing with the BCM, it is a computer, nothing more. https://www.google.ca/search?q=2017+DODGE+JOURNEY+BCM ..

Question edited for clarity.

Dodge Caliber (2006-2012) fuses

Fuse Box Diagrams https://fuse-box.info > dodge > dodge-caliber-2006-20... Fuse box diagram (location and assignment of electrical fuses) for Dodge Caliber (2006, 2007, 2008, 2009, 2010, 2011, 2012).

Dodge Caliber fuse box and relays diagrams

StartMyCar https://www.startmycar.com > dodge > caliber > info > f... Dodge Caliber fuse box and relays diagrams. Explore interactive fuse box and relay diagrams for the Dodge Caliber. Fuse boxes change across years, ...

Layout of the fuse box ' Page 2

Dodge Caliber Forum https://www.caliberforumz.com > threads > page-2 Every Caliber has the fuses listed in the Owner's Handbook Integrated Power Module (IPM) The Integrated Power Module (IPM) is located in the engine . ..