Dynex Televison & Video - Page 3 - Recent Questions, Troubleshooting & Support

Hello? This could be an issue with back lights or T-con. If you look the tv in a fairly dark room, it is most likely that you will see images but from a far. If this does not help, ask more here Ask question Electronics questions answered

Dynex Televison... | Answered on Oct 18, 2018

I would certainly have a servicer check the Cable/satellite box. I have seen this with Dynex TV. But try this. Power off box, if there is a service card, take out, unplug box for one minute. Plug box in, insert card and power up. If there is no card, do as said...only. Let me know what you find out. Matt of Martins TV Repair.

Dynex Televison... | Answered on Oct 04, 2018

Contact Dynex. Screws must be of the specified metric size and length for safety.

Dynex Televison... | Answered on Sep 14, 2018

Lodgingstar remote controls are unique to the hospitality industry. They will not work at home.

Dynex Televison... | Answered on Sep 08, 2018

Try opening it manual with paper clip od needle. On front side of dynex, there is a little hole near disc tray. Try puching needle or paper clip in that hole until disc tray open.

Dynex Televison... | Answered on Sep 03, 2018

Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.

In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.
Before going further; try a hard reset first. If it does not help you, replace the main digital board. There are two methods to reset TVs. The first is simple to do; a Hard Reset. The other is somewhat skilled; is a Factory Reset (System Reset). To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. If you do this by overnight is better. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; visit the site linked here.

Dynex Televison... | Answered on Aug 29, 2018

Not finding what you are looking for?
Dynex Logo

2,277 questions posted

Ask a Question

Usually answered in minutes!

Top Dynex Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76171 Answers

Cindy Wells

Level 3 Expert

6046 Answers

Vitally Alcher

Level 3 Expert

1645 Answers

Are you a Dynex Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides