Epic Exercise & Fitness - Page 8 - Recent Questions, Troubleshooting & Support

Have you loosened the motor. This is a tricky job. Can be a bit dangerous to your face. Be careful.

Please post the specific model # found on the model/serial# decal on the frame of the machine (EPTL....) Who replaced the drive motor on the machine, and for what reason? Did the new motor ever function when installed?

follow this steps and fix it. God bless you Unplug the treadmill. Locate the console key and place the safety or reset key into the treadmill console. Replace any parts that need replacing, or is large enough to trigger with a pencil eraser or Q-tip. Plug the treadmill plug back into the wall. Use the Q-tip to press the reset button. It may be necessary to hold the reset button down for a few seconds. "CL11" will appear in the display of the treadmill.

• 3

Press the reset button one more time with the Q-tip. "CL21" should appear on the screen. Press the enter key. The display will change again and show "CL22." Keep pressing the enter key until the numbers cycle through to the number "CL26." Press enter one more time. The letter E should appear on the display screen.

• 4

Press enter twice more. The letters "SS" should appear on the screen. When this happens, press the start/stop key. Making sure to keep well away from the tread, press enter to start the treadmill. The treadmill will start on its own. The treadmill will stop on its own after a few seconds. When it stops, press the power key two times. Remove the safety key and put in a safe place. Your treadmill is reset.move on to the next step.

• 2

Locate the reset switch on the underside of the treadmill console. Usually the button

1) tight the upper and lower connectors and clean it.2) tight the ribbon cable inside from display board.3) adjust the reed swith, see the diagram attached.4) test the power supply for display board +5 or 12vdcGod bless you

see the video attached, and follow the step. God bless you

1) is more easy to fold 2) However if the place is impossible to move you must disassemble the treadmills read your owner manual or download from www.fitness.manualsonline.com see the video attached. God bless you

Please Run the utility software calibration for easy diagnostic and fix it. Go under the Hood cover motor, follow the steps .God bless you

Run the utility software calibration for easy diagnostic and fix it. Go under the HOOD cover motor, and follow the stepsGod bless you

SEE THE VIDEOS and proceed according. God bless you

see the video attached and fix it. God bless you

RUN the software calibration for easy diagnostic and fix it.Go to the HOOD cover motor, and follow the steps , or use the owner manual for follow the steps.God bless you

RUN the software calibration, and test the machineGod bless you