Fagor Dishwashers - Popular Questions, Answers, Tips & Manuals
Fagor dishwasher is showing F2 please help.
Not drained in time allowed (6 minutes) - washing machine fails to drain water
- Check that filter is not blocked or obstructed
- Check drain hose is clear of any blockage or obstruction
- Check wiring to drain pump
- Check drain pump is not defective
- Check level sensor or switch
- Check wiring to level sensor
8/12/2016 10:36:16 PM •
Fagor...
•
617 views • 0 helpful votes
DOOR FELL OPEN AND WON'T CLOSE, FEELS VERY HEAVY
Dishwasher doors are balanced by a set of opposing springs that, over time, can stretch and or become defective.
Get your model number and look on line on an Google search or bing. One can find a number of sources for the needed parts to repair this problem.
What is this? I can't find it in the manual. I turn on the dishwasher and nothing happens.
I think your problem is with a bad contact switch. Most likely at the door. When door is closed this switch makes contact to engage machine to start. Your machine is electronic, some machines would need a lever to be moved to enable machine to be started. It all comes down to the same thing, power must flow to start the washing. You will need to look for this contact somewhere around the door. GOOD LUCK FRIEND.
Fagor dishwasher showing f6
Please check fault codes on page 70 in this manual.
http://www.fagor.co.uk/documents/LFU-65iT.pdf
F6 would mean the water is not getting heated. I am not sure which model you have but if there is only a cold water inlet connection then either heater or thermostat is faulty. If you have both hot and cold water inlet then you may have to check if hot water is getting in at right temperature. Easiest way to confirm is to run dishwasher in cold cycle (short rinse) and see if it goes through. The heater would get used in warm/ hot wash cycles and drying.
9/19/2014 9:59:06 PM •
Fagor...
•
948 views • 0 helpful votes
Not finding what you are looking for?