Fisher Dishwashers - Recent Questions, Troubleshooting & Support
Fisher and Paykel DS603 no power
Hi,
There is a thermo fuse in this unit and it can cause the controller not to power up. It is located on the heater plate, if the unit got too hot this will cause this fuse to blow and cause not power to the controller to a singe drawer unit only, this would not shut down both drawer though. This fuse is not replaceable other than replacing the plate itself. Get back to me if you need part numbers and I can get them for you or you can call Fisher and Pakel directly and they are 24 hours a day service call center. The plate is tricky to replace and you will have to change both seals at the same time, not real pricey though.
I hope this helps, keep the unit, its a good dishwasher.. Good Luck I’m happy to help further over the phone at
https://www.6ya.com/expert/gere_bf68e6055dd61249
F4 error fisher & paykel nautilus dishwasher
F4 is a heating error- dishwasher has not reached temperature in allocated time. If intermittent fault, problem is usually with electronic board, which has temperature sensor attached. Sometimes the wiring to the control board burns out and can give intermittent false readings causing F4 error.
Disconnect from power, remove front panel (4 screws down each side). You can now see wiring going to control board- check for burnt wires. Also check temperature sensor (small square with two purple wires) is stuck to inner door panel- if this is not stuck to inner panel, temperature sensor will not work properly. If in any doubt, call in the experts!!
1/2/2023 2:31:37 AM •
Fisher...
•
Answered
on Jan 02, 2023
Hi, how do I fix error code F1 of a fisher & paykel draw dishwasher??
The F1 error on a Fisher and Paykel dishwasher means the flood switch was activated for seven seconds or longer. ... The dishwasher's flood switch could activate because the water is leaking around the heater plate. It would still eventually show up somewhere, though a leak like that would kill the heater plate too.
11/5/2018 12:49:46 AM •
Fisher...
•
Answered
on Nov 05, 2018
Fisher packed dishwasher dd603
If the panel display on the lower drawer is lit and you can select the program then most likely the water inlet valve is fault and needs replacement. But if the panel is dark and none of the buttons operate then the power to the drawer is cut off. This can be due to a number of reasons including the power board at the base loosing one power circuit or the thermal fuse in the drawer is blown. Please provide model number of dishdrawer unit and also please describe what is actually happening.
3/7/2018 12:43:19 AM •
Fisher...
•
Answered
on Mar 07, 2018
Not finding what you are looking for?