Fisher and Paykel Washing Machines - Page 10 - Recent Questions, Troubleshooting & Support

blocked or faulty drain pump

with power to machine but all lights off press temp water down button and power button at the same time machine will give two short beeps release then pree spin speed up button three times the lights that are now on is you fault code

one of the suspension rods is eith not attached or broken

replace the cold water solenoid

no you cant the bowl just hangs in them, if it keeps going out of balance put a new set of suspension rods in

if your good with your hands they are the easist machine ever to do them on

there is a lid switch located under the top of the machine on the right hand side activated by a magnet in the lid this is probable faulty

blocked or faulty pump

one of two things shorted out drain pump,or main board is blown, try pump first

the switch is faulty replace the switch

this code indicates a faulty main board

this code imeans a faulty rotary position sensor and easy fix

the cold solenoid is faulty

do you mean fuse ? if so its on the main computer board

as this fault doesnt exist i would say the main board is faulty

most likely a faulty pump try tht first

easy as remove cap off the top of the agitator,inside at the bottom there is aa wing nut undo anticlosewise and remove agitator

its one of tricky ones,because its one of two faults, both are board faults question is which one so you need two replce and try it if tht doent work replace the other one

this is a fault code 43 which mean the out of balance switch is either faulty or the switch isstuck in the on positionfree up or replace switch which is located just under the main board

faulty cold water solenoid replace with new one