Fisher and Paykel Washing Machines - Page 9 - Recent Questions, Troubleshooting & Support
Hi there, I have a
under the top of the machine on the right there is a reed switch which is actic=vated by a magnet in the lid remove the two bungs and screws so you can lift the top up a bit and you will see it there one screw to remove it if its corroded or swollen its faulty either repace it or as a easy fix cut both wires off it and join them together and tape up, this should do it
Hi I have a fisher
if it keeps filling until it floods the it has afaulty transducing which is locatedin the mainboard which will have to be replace
Replace the control board on
check out the drain pump as it is linked directly to the main board any burning smell or discolouration of the copper windings replace it
I have a Fisher &
burning smells are most common from the drain pump remove and sniff it if it smells like its been getting too hot replace it
Fisher Paykel GWL11 fault code 130
its really important the R.P.S you replaced is correctly fitted so double check it,also the connecting block if corroded in anyway will cause the faulty its easy to see the bluey color of corrosion, i have struck faulty new sensors beforebut not all thst common if you are really sure all that is 100% then it can only be the wiring loom
How do you go into fisher and paykel diagnostic mode
with power to machine but all lights off press temp water down button and power button at the same time machine will give two short beeps release then pree spin speed up button three times the lights that are now on is you fault code
Not finding what you are looking for?