Fisher and Paykel Washing Machines - Popular Questions, Answers, Tips & Manuals

Tip

Fisher and Paykel washer GWL11 bearing replacement


Take a look at this video to see how to tear down and replace the main bearings in this washer.

on Nov 02, 2019 | Fisher and Paykel GWL11 Top Load...


Hello, Keith -

I suggest you contact Fisher and Paykel Customer Care and ask your question directly. I have no idea the country where your washer was manufactured. Therefore, following are the links for country of manufacture:

USA: https://www.fisherpaykel.com/us/ Choose "Help & Support"

Canada: https://www.fisherpaykel.com/ca/ Choose "Help & Support"

New Zealand: https://www.fisherpaykel.com/nz.html Choose "Support"

Australia: https://www.fisherpaykel.com/au.html Choose "Support"

Fixya receives questions from people worldwide. I am answering from the USA.

Best wishes.

Fisher and... | 29 views | 0 helpful votes


What appliance is it?

Fisher and... | 38 views | 0 helpful votes


if its a top loader then a faulty motor controller.(computer main board )

Fisher and... | 71 views | 0 helpful votes


that is a sizing problem ,if neither board has been replaced recently,then faulty board

Fisher and... | 62 views | 0 helpful votes


That means that power is being applied to the drain pump when it shouldn't be. There is only one reason for that, a fault in the main control board. You will have to replace the main board.

Fisher and... | 43 views | 1 helpful votes


Hi, you should beable to put a thin knife into the slot on the little door flap at the front on the right side and gently pull the door flap down, then unscrew the plug and the water will drain out, put a larg try underneath to catch the water, best to undo the plug enougth so that when the tray is full you can tighten the plug why you empty the tray, all the best.

Fisher and... | 420 views | 1 helpful votes


would need more info

Fisher and... | 576 views | 0 helpful votes


It beeps to tell you there is an error. While it is beeping & before pressing any buttons, read the error code & write it down. The error code is the lights along the top row. Count from left to right and make a note of exactly which lights are on and which are off. There are 8 lights, you need to say exactly which number light is on. Post the result back here and someone will tell you what that error code means.

Fisher and... | 103 views | 0 helpful votes


Make sure that the washer drain hose is at least 30 inches above where it comes out of the washer or 38 from the ground. the washers drain hose needs to be typically higher than the washer. Could also be a faulty pressure switch depending on the washer See video link.

.https://products.geappliances.com/appliance/gea-support-search-content?contentId=17418

Fisher and... | 34 views | 0 helpful votes


each element switch controls the heat to that element so those switches need to be replaced ,technical name is simmerstat

Fisher and... | 47 views | 0 helpful votes


remove pump check foe anything that may be jamming it,at the same time check the copper windings for any discoloration ,if any replace pump,faulty pumps get hot and after a short time switch off due to a built in thermal cut out

Fisher and... | 54 views | 0 helpful votes


Error code 136 motor stall. Can be caused by several things. 1. Faulty wiring or copper stator in motor. Check with ohm meter. You haven't said what model so I can't tell you what your ohms should be. 2. Faulty RPS (rotor position sender) That little circuit board on top of the stator. You need a special RPS test meter to check it. 3. Drum seizing up. Try spinning the steel bowl by hand, it should be very easy to rotate and no loud bearing noise. 4. Faulty main control board. Don't worry about the cracks in the stator. Nearly every machine I work on has cracks. It doesn't affect performance.

Fisher and... | 322 views | 0 helpful votes


Google it perhaps they have answer there for you

Fisher and... | 1,102 views | 0 helpful votes

Not finding what you are looking for?
Fisher and Paykel Logo

4,180 questions posted

Ask a Question

Usually answered in minutes!

Top Fisher and Paykel Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

jimorris77

Level 3 Expert

411 Answers

peter gittos
peter gittos

Level 2 Expert

247 Answers

Are you a Fisher and Paykel Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...