Fisher and Paykel Washing Machines - Page 9 - Popular Questions, Answers, Tips & Manuals
I have a washing machine
thats normal when you turn it on at the wall then you press power button and all lights should come on,if it is slow to fill on cold wash you will need to replacethe cold water soleniod
6/28/2017 3:30:03 AM •
Fisher and...
•
65 views • 0 helpful votes
New Motor Control Board
You say nothing happens when you press srart but then you say about reading the fault codes. So if there is beeping and fault codes then it must be doing something. Describe exactly what happens, step by step. What do you mean by the new board is same number but not the same? What is different? Recheck the wiring, especially the hot & cold inlet valves.
5/15/2017 10:12:03 PM •
Fisher and...
•
154 views • 0 helpful votes
E6 error code on fisher and paykel dishwaher
The code E6 is for the flood switch
Pull the appliance out, tip it back about 45 degrees and see if water runs out of the base.
If it does, drain the base (under where the tub) completely and the anti flood should reset.
If there is an aquastop device on your fill hose, after draining the base, turn off the water supply, disconnect the aquastop device and allow it to de-pressurize. Connect it back up and try again.
If it happens again, you'll need to check for a leak.
The normal cause is over foaming, using multifunction tablets and rinse aid, or just spilling rinse aid.
12/28/2016 3:42:40 AM •
Fisher and...
•
7,714 views • 1 helpful votes
Fisher & Paykel smart drive - all the lights come on!
It has put itself into the display mode (used in shop displays) Try turning power off and unplug from the wall outlet for a couple of minutes. Plug back in and see if it has come back to normal. If not then either the display board or the main board will need to be replaced. Get a service tech out to check which one is faulty.
5/13/2017 7:27:03 AM •
Fisher and...
•
130 views • 0 helpful votes
Cold water valve?
Replace the inlet valve. This is a common fault easily fixed with a new valve.
4/7/2017 10:00:04 AM •
Fisher and...
•
319 views • 0 helpful votes
I have a AW095AU top
sounds like a faulty rotory postion sensor which is located on the stator which is under the bid white cover at the bottom of the machine
5/12/2017 5:33:04 AM •
Fisher and...
•
107 views • 0 helpful votes
Won't spin gw608u
Fault code 41 if those are the correct lights. Service manual says faulty temperature thermistor & change the control module. Good luck with that as that model is nearly 20 years old and I don't think F&P supply that module any more.
Not finding what you are looking for?