Frigidaire Washing Machines - Page 7 - Answered Questions & Fixed Issues

Please tell us what the problem is with your particular washer.

sounds like you need a new timer

Most likely suspension parts related. Maybe a bearing or spider arm.

Check door latch. It may need replacing

Try unplugging for 5 minutes

It is not removeable.

Yes at 22 years old its going to break. Buy new. Tge tub is no longer available for that

Give the drum a spin to see if it's bound up. If no resistance, it could be that the drive belt snapped.

Hi,
If you are having a problem with your top load washer then check out this tip...

Washing Machine does not Pump or Spin
http://www.fixya.com/support/r4617986-washing_machine_not_pump_or_spin

If you are having problems with your front load washing machine then checkout this tip...

Front Load Washing Machine not draining and or not spinning
http://www.fixya.com/support/r4784376-front_load_washing_machine_not_draining

heatman101

It’s connected to drain pump in bottom of machine. You’ll have to determine what has to be removed to access pump.

Frigidaire Affinity Washer Error Code E41 = Control board thinks the door switch is open. Usually replacing the door switch fixes and clears the error code.

yes it can, but no one can tell what parts are needed as they are not there to look at it. best solution is to call for service.

waste water outfall pipe blocked or kinked.......... cheers

On occasion, the manufacturer will in include paperwork inside of the back. You would have to remove the rear cover or panels.

Any error codes? Drain pump may be blocked.

Sounds like the water pump seal may be leaking.

This sounds like a similar fault I repaired on a Fisher Paykell top loader smart drive. It would fill up, start it's wash cycle (you'd hear the engine turn back and forth ) and a second later stop. It turned out that a position sensor on the motor had failed due to a small water leak. I'm unable to find the motor for your model of Frigidaire to see if there is a similar sensor or pick up module though.

I don't understand SHANE circuit board. IF you replaced the board, it has been upgraded and you need to order a new wiring harness for it. Please post the model number

Check if your water supply is coming in very well

We have a code of efo