GE Vacuums - Recent Questions, Troubleshooting & Support

Contact GE with the model number and they should be able to help you

There are different models that take different belts. Do you know your model number?

The first problem is the time you will use a product of the very old time , and ask you not wonder what it mains happened in the interval between 1930 and 2016 maybe its not only the changeof 110V to 120 volts it is not much difference but far enough to worry and what the effect is on the heat dissipation of the heating element inside (the coffee must be too hot 90 and 95 degrees are normal all the cables and more parts of Should Be Replaced if it was not modifiedin all Those years, it Should Be modified, and it was modified there must be for shure a big wire resistor be Placed in serial to release to the high aC power on the heating element. and maybe many more parts. gaskets cables and more must Be Replaced iif not safety for all. preventinfo and usefull to a hot Become bitter tasting coffee temperature.

Probably should just go to a repair shop and they should be able to order one for you, that is if they are available by themselfs. Or if you have a store where you live that sells vacuum parts, you could go there.

Parts for 106585 Ge Vacuum Cleaners I may have found what you need.

Eureka belt EXT-U

Google location

Open door, remove handles, arm rest etc. then door panel screws and then with a thin blade tool like a putty knife or a proper trim panel tool feel out where the internal fasteners are and pop them out with a force pushing the panel away from the door.

there is an open gap somewhere prior to pick up point, or blocked air flow or too much dirt on bag. check hose for crack as well. hope this helps.

Using a small hammer proceed to smash the clear plastic

belt tensioner is on right hand front of engine slacken it off full and use bolt head to turn centre piece until desired tension then lock

Yes, the GE Walmart Upright Vacuums take Eureka "U" Belt.

Here is a link to help you troubleshoot this http://www.freeasestudyguides.com/exhaust-color.html

Something is probably restricting the brush roll from spinning freely. Make sure both end caps rotate free.

It sounds like your sensor in the braking system is going bad or is loose. I had a 2004 Dodge caravan and the sensor was around my brake pads.