GE Washing Machines - Page 8 - Popular Questions, Answers, Tips & Manuals

Likely pump failure.

Check suspension rod bushings at top.

check the breaker. is it a gfci?

Stability arms are the problem if it leaks during the Spin cycle. If it leaks on Wash or Rinse, the pump is bad.

https://products.geappliances.com/appliance/gea-support-search-content?contentId=19152

Did you replace main control board or motor control board?

No it work with th electronics so the machine will operate and reset for each load

Probably something stuck in drain pump or pump is defective

Maybe motor is overheating and shutting down on longer cycles.

Lid switch may be bad

Check on line normally the manufacturer will have the book or pictures on there site

Most likely a failed transmission

Some GE washers with power wash option are designed to only spin during final rinse if that option is chosen.

Try this Bill... https://products.geappliances.com/appliance/gea-support-search-content?contentId=17391

Under the hub nut there is a washer around the shaft. It can help it from coming out. After u remove that spray some easy out on it

Check belt. And check motor

If you are you able to turn the agitator by hand, then it is likely that something has failed. Bearings can and do fail without noise or residue. If you know what you are doing, then I suggest you dismantle the machine completely and find the part that has failed. If you do not know what you are doing, then find a repair centre that works on this make.

Motors in that model are computerized. It possibly could be motor needs replacing.

Lid lock is most likely bad

Checking belt would be 1st step.