Hoover Washing Machines - Page 4 - Answered Questions & Fixed Issues

take down make & model # contact manufacturer technician line, you may also turn your power on and off to wi-fi and retry to see if it works

E08 is the motor speed sensor error code. Suggestion: Try a cycle with very few garments and see if it completes the cycle.

Try unplugging for 5 minutes. That may reset electronics

Error code E08 means overloading (too many clothes in the drum). Don't worry, just reduce the load size by removing some of the garments in the drum.

Probably a problem with door lock. Most likely replace it.

Check if the machine is on drip dry cycle. Make sure it is pumping out. It wont spin until the water is out. There may be a blockage in the hose or pump. Check the belt may have broken. Worst case is the transmission has failed. If there is a tide mark of orange rust / grease around the inside of the cabinet, its a sign the drive has failed.

sound like an electrical circuit problem..I had to have mine changed. There are circuit boards that control these functions.

Hi! I'm adding a link to a manual of Hoover Tumble. Hope it will help! https://manualsbrain.com/en/manuals/754807/?page=12

It’s a door lock or motor related error. Make sure drain pump isn’t obstructed.

https://www.espares.co.uk/advice/careandmaintenance/how-to-fix-an-e08-error-code-on-a-hoover-washing-machine Hope this helps.

lower the drain hose past the tub level and the water will drain out if inside use a bucket to collect the water when empty switch off the taps and use the spin cycle to dry the clothes

I have hoover vision hd 1400 aaa
In proble stain blaster
I oll redy clean thing and check water vest pipe
Nothing to blocking

Im not a specialist in this but to my knowledge, Will the unit spin if you manually turn the timer dial to spin? If so, remove power, remove the clock motor from the timer, and inspect the clock and mating timer gearing for debris or damaged gear teeth. At the worst, replace the timer. You may be able to scrape or file the damaged teeth so that the timer will progress.

Have someone look under the machine and see if it has a drive belt from the motor to the pump. If it does, the belt could be worn out and slipping, causing the drum to not spin fast enough. God bless your efforts.

https://www.espares.co.uk/advice/careandmaintenance/how-to-fix-an-e07-error-code-on-a-hoover-washing-machine How to Fix an E07 Error Code on Hoover Washing Machine

Follow the link to a tutorial of how to repair this fault code. https://www.espares.co.uk/advice/careandmaintenance/how-to-fix-an-e05-error-code-on-a-hoover-washing-machine

The easiest thing to do is just unplug it for a few min's

motor nor spinning could be a seized bearing , jammed impeller blades or start /run capacitor or a burnt out motor windings

check for broken or cracked lines tank