Hotpoint Washing Machines - Page 2 - Recent Questions, Troubleshooting & Support
Replace bearing Hotpoint aqualtis aqd970f 69 eu
It is possible to replace just the bearing on your Hotpoint Aqualtis AQD970F 69 EU washing machine, however, it can be a difficult and time-consuming task. The best course of action would be to consult the manual for instructions on how to replace the bearing, or watch a YouTube video that specifically relates to your model. You may also be able to find the necessary parts on websites such as Amazon or eBay. However, it is advisable to get the help of a professional technician to do the job if you are not comfortable with performing the repair yourself.
Hello I've got a hotpoint washing machine model wml520 the electric door switch had melted on it I replaced it with a new one but the washer won't start any ideas thanks.
If your Hotpoint washing machine is not starting after you replaced the electric door switch, there could be a few different issues causing the problem. Here are a few things you can try to troubleshoot the issue:
- Check the power supply and make sure that the washing machine is properly plugged in and receiving power.
- Check the fuse or circuit breaker to make sure that the washing machine is not tripping any electrical circuits.
- Make sure that the door switch is properly installed and fully seated in the door latch assembly. If the door switch is not properly installed, the machine may not start.
- Check the wiring and make sure that there are no loose or damaged connections.
What does "f08" mean on
The error F08 indicates that the heater relay is stuck.
This could be a fault with either the pressure switch, heater or the module connections.
Think you need to book a service call from engineer.
Error code on display panel
F-12 is a drain problem.
Check if the drain hose is free, if cycle stops and gives you f12 without draining the water, there is a problem with the drain system.
The Hotpoint should have a removable paner at the back on the lower side. The panel gives access to the pump. If cleaning the drain hose does not solve the problem, the pump must be removed and cleaned or replaced.The repair should be done by a technician.
As this wd640 is a washer dryer, im sure there
Hi.
Yes there is a filter.
Remove lower rear panel of washer.
Remove large black hose onto bottom of drum.
Remove and clean filter inside hose.
Remove hose on to pump, check for obstruction or blockage here, and look inside the pump as well.
This should solve your problem.
10/21/2022 9:46:36 AM •
Hotpoint...
•
Answered
on Oct 21, 2022
Washing machine door wont open on hotpoint
remove the front kick strip, on the LHS you will notice a yellow tag. with the power on on the machine pull down twice gently on this tab. this should unlock the door.
if you now notice the drum is full of water its more than likely your filter is blocked and this is what caused the door not to open.
Not finding what you are looking for?