Iomega storcenter ix2-200 hard reset
Please help with this issue.I can access the drives but cannot access the system webpage and configuration. I am using the same ip address as above but page is not loading. the iomega storage manager is also not working even after updating to the latest version. Please help.
12/22/2022 12:44:21 PM •
Iomega 2TB...
•
Answered
on Dec 22, 2022
Cannot connect to iomega storcenter ix2 with second computer
Confused dot com.
You say it is directly connected to your first computer, not through a router.
That may be your problem.
Try connecting it to the router. Putting it in the same network as your group of computers, and run the finder software on each pc.
12/23/2021 7:15:13 PM •
Iomega...
•
Answered
on Dec 23, 2021
It says no boot device
>Do you have an operating system installed on that drive? If you have an operating system installed on that drive and are trying to boot from that drive, check and see if your BIOS will allow that. Many will not. The beeping is not coming from the external drive, it is coming from your computer's system beeper. Usually those beeps are in a pattern that is a code for what the problem is. Check your computer manual booklet.
Blinking light on iomega external hard drive
Try plugging the unit into another working computer. If the same thing happens then the external drive is toast. U may be able to remove the drive with within the unit, set it up as a slave, install on working computer and possibly extract any and all needed files before throwing it out.
I have accidentally formatted the
ScreenPlay Director Partitions
There are five partitions on the ScreenPlay Director's hard disk. Three partitions are grayed out and will list as "Healthy-Unknown" in Windows Device Manager. These partitions contain the ScreenPlay TV interface and system settings and are not available to store media files.
The two active partitions both appear as "Untitled". The larger partition is formatted with an NTFS file system. Use this partition to store your media files when you connect to the ScreenPlay Director from a networked computer or transfer files via direct USB connection.
The smaller partition is formatted FAT32 and is used only when updating the ScreenPlay Director firmware. Do not place your media files on this partition! If you accidentally store media files on the FAT32 partition, you can use a computer to move them to the larger NTFS-formatted partition. You will not be able to see media files on the FAT32-formatted partition when using the ScreenPlay TV interface.
Formatting the data partition will erase all existing data! If you have files on the ScreenPlay Director you want to save, move them to another drive or volume before reformatting.
*******************************************CAUTION!*********************************************************
Do not change (format or delete) the partitioning on the ScreenPlay Director hard disk as this will remove the firmware that enables the ScreenPlay Director to communicate with your TV set. Only media files stored on the active data partition (the largest partition) can be viewed or played on a TV. The ONLY partition that can be formatted is the data partition (the largest partition).
Conclusion: If you have deleted or formatted any of the first 4 partitions on the unit that is not the data partition. You now own a BRICKED ScreenPlay which HAS to be replaced. No if ands or buts about it. YOUR DEVICE IS DEAD.
7/11/2020 5:14:02 PM •
Iomega...
•
Answered
on Jul 11, 2020
Problem playing avi files
"can't play media (bad container)":
The video bitrate (file compression) is to high and needs to be re encoded at lower bitrate(kbps).
10/15/2019 7:29:05 AM •
Iomega...
•
Answered
on Oct 15, 2019
Unknown format
It means that the player cannot support the video, just try a
video converter to check out if there is any problem with the video.
Not finding what you are looking for?