Jacuzzi Pool & Spa - Recent Questions, Troubleshooting & Support

If you have any clamp on amperage meters, you need to see what the amperage draw on the circuit is when it is running. This will tell you if something is wrong with the pump circuit. It could be anything from a bad capacitor to an impeller obstruction.

No jacuzzi magnums do not have a reset button. First make sure breaker to pool is off, then remove rear motor cover, and take a look. Popping noise sounds like an arked wire. Could be a bad terminal or just aloose power wire. JACUZZI PUMPS ARE GOOD QUALITY, AND USSUALLY RUN FOR MANY YEARS. Pump can be removed for repaair, or motor replacemant by a qualified, and republe pool shop, for rebuilding Ussually rebuilding is about half the cost of new. Kirk

https://www.youtube.com/watch?v=XE6r7V80Rzg

Impeller may be broken or clogged. Turn the pump off and remove the basket. Reach back into the pump with your fingers and see if you feel debris. If you can't reach or if there is debris you will need to open the back of the pump, take off the diffuser, and clean out the impeller.

rollout switch on lower inside cover by burn rack and gas valve possible down draft pushed flames into cabinet and tripped it if keeps happening might need chimney if ok check gas pressure if low unit overheated or burner tube clogged

Without knowing the code it could mean anything. Consult your owners manual or online manual for error codes and remedies.

You have a: Single Stage Jet Pump, c/w Cast Iron Construction, Thermoplastic Impeller, .... coupled to a : 1/2 HP, 115/230 Volt Motor with a 1" x 1-1/4" Discharge x Suction. If you can't find a Jacuzzi, you can always replace it with one of like specs. Check a local plumbing supply dealer or online ... https://www.grainger.com/category/well-pumps/pumps/ecatalog/N-hve This may also help:

probably the element shorted out and caused the problem get in an electrician to check the wiring and circuits

This is a bad main board issue