Jet Saws - Recent Questions, Troubleshooting & Support
Blade size
There are two common blades: Eight-Inch Table Saws are a good choice for crafts and other applications associated with thinner stock.Ten-Inch Table Saws provide the extra cutting depth needed for angled cuts in thicker stock.
Jet table saw JWTS-10CW2 blade
The table needs to aligned with blase and mier slots. I used a dail caliper to measure distand
ce from the front of blade to rear of blade. Use a piece of tape to mark tooth and use that tooth to measure front and the rotate and measure back. usually there are 4 bolt that hold table. Lossen only 3 and slack off the 4th to help hold table . Use a block of wood and hammer to tap table in alignment. DO NOT GET WILD or you will have more work resetting everything. The alignment is usually of a small amount. Good Luck
Manual chain hoist keeps slipping load chain when
sounds if the motor brake is not holding , this is a wear part and will require adjustment/replacement over its life time , the brake is located under the motor cover , but if your not sure what to adjust ,then im gonna suggest for safetys of you and the people around it' s sake you get a profesional to service this hoist
Therma Overload Switch
If you have not supplied enough power (like using an extension cord) the motor sees a big voltage drop, starts drawing a lot of current and eventually overheats. Make certain to use a good supply.
JET Tools
2/5/2015 9:19:38 PM •
Jet Saws
•
Answered
on Feb 05, 2015
How do i adjust the blade tilt
There should be 2 handles: height and tilt. Tilt is typically located perpendicular to the blade on the base of the saw.
1/28/2015 8:38:11 AM •
Jet Saws
•
Answered
on Jan 28, 2015
Not finding what you are looking for?