JVC LT - Answered Questions & Fixed Issues
My JVC 58in. Flat screen blinks?
The cable connections for your TV are not connected properly or are loose or the cables might have damage or the connection ports are broken.
How To Set Time on Television
lost the manual right? in the box new, but lost.
call your seller and ask for the manual?
it is not a computer at all so moved yah to Television forum.
so now you might get hits.and use the JVC african web site
is the only place you can get a manual not wrong as our USA site would fail.
did the TV new ,was it sold in AFRICA?>or else where.
if not there where, , tell JVC that not me,
set the time, my TV has no time. so yours must be unique.
or 785 here shows
press menu button
push << or ?>>. to time menu.
push ^ or down to set time.
ok to end
done.
best is a manual matching your exact TV and there are none here.
TV won't turn on (completely)
moved you to television forum random model not told.
lost the remote
first TV ever?
and batteries died in remote, I am on set 24 batteries in 12 years.
see how batteries sux
all TVs have reset,
ever read the manual first after all no 2 TVs are the same.
so we read the manual
screen is dead but are menus dead.
the rear of all TV s made a label and we read it and the model is there. like my wild guessed one top of this page;.
post you real model or get no answers correct. ever.
if TV is older than 2010 CCFL lamps inside are dead. use flashlight to see that is ture or not.
on my TV the red LED goes out turned on, so you do no have to start at it forever, a huge pain that but must turn out or PSU is dead in TV or the silly batteries in the remote are dead, or weak
read that word 2 times for effect, WEAk.
JUST BOUGHT TV WENT TO ADJUST COLOR WAS CHANGING
Call 1-8O5-465-751O Number To Fix
Try calling the service center for technical help at these numbers
Check the
status of a repair at any of the locations below.
California Factory Service Center
JVC Factory Service Center
5665 Corporate Avenue
Cypress, CA 90630
(800) 252-5722
Georgia Factory Service Center
JVC Factory Service Center
1500 Lakes Parkway
Lawrenceville, GA 30043
(800) 252-5722
This was all the Jvc.com website had to offer for customer service on the website. Hope this helps you with your problem.
JVC LT 32E479 UNABLE TO SWITCH ANY CHANNELS
Please my jvc television couldnt change to stellite channel when i was offing it mistakenly pressss the +button i have been trying to change channels but i couldnt please is there any solution to that?please i need urgent help
12/9/2018 12:59:11 AM •
JVC LT-32E479...
•
Answered
on Dec 09, 2018
•
1,242 views
Jvc no power when plugged in
you tube might have blown ouy that's a big problem.Next time make sure you plug your TV in a surcharge protector
I a 2007 JVC LCD HDTV and when I turn it on it is
I am guessing the CCFL tube is starting to burn out. Replacing is not impossible but somewhat delicate process.
Since the TV is that old i would recommend you to buy new TV instead when it goes completely dead.
I have a jvc LT-32EX38 lcd Flat television well I
you didn't say what kind of antenna you have attached to the TV. The antenna is very important and the type of antenna you need is based on where you are in relationship to the television stations in your area. Even being down a hill In the area can be a problem for antenna television. I had to put an antenna in my attic because an in-door antenna could not pick up the signals for the TV stations in my area, I am down a hill.
I have a JVC LT 26X575 that will not accept remote
sounds like the remote batteries could be bad or the buttons on the remote need to be cleaned. some JVC TV remotes, I'm not familiar with this particular one though, can be cleaned using a clean pencil eraser. Be careful opening the remote because some parts can fall out or you can damage the connections to the LED emitter that sends the signal to the TV. Also the solder connections on that LED could be bad.
The picture of our jvc LT-46FN97 will suddenly distort
Sounds to me like the digital pixeling that occurs with a weak signal. You have not identified whether this happens on broadcast/antenna TV, cable or satellite service, or a video input such as a DVD. This can be a common problem if you have a weak signal on any of those inputs. In any case, blowing out the dust will not help.
Not finding what you are looking for?