Kenmore HE2 - Recent Questions, Troubleshooting & Support - Page 4

Check the shocks on the drum to make sure they are ok. if they wear out the drum spins out of balance and the computer wont allow it spine because it would WALK and damage itself.

sounds to me like they are jerking you and trying for more money, I would check the lid switch components with a meter.

hi mate you must have a bra wire caught in drum ..try this

missing retaining screw or clip will pop off each time till properly hooked up

I would replace the Motor control board.

5d is a definitely a the code for a plugged discharge. We removed the lower access panel and discovered a virtual treasure: $12.50 in quarters, nickels, dimes and pennies, a pen, a pencil, collar stays, 10 bobby-pins, 3 barrettes, a elastic headband, a draw string, a box cutter, 3 washers, 3 broken zipper parts, a elastic waist band. Amazing it took all to trigger a 5d error code. Hope this helps!

After years of suffering from random F11 that became a permanent F11, I did the repair as in the video and all is good for 2 years. No more F11. About one load a day (we have kids!)

Pump blocked.prob

Your pump is blocked.prob a hair bobble coin etc... try the pump access at bottom of machine water will come out so u need to open it slowly

try making it level

check the pipes from the water main and the pipes in the machine could be a seal has gone

We have the exact same washing machine, and the same problem. we will need to lift the front of your washer up and undo the bolts to the front cover. you will see a white round turn nob, this is the filter unscrew it (you kight plug your nose) and empty all contents, replace, screw the front plate back on and you are good to go!

Hope this helps, i wish someone would of helped us!!

good luck

Can you re ask the question with better wording please.

F33 message check pump drive system error, broken wire, corrosion, junk in pump filter

Try putting it on drain and spin cycle. I could give a better answer with a model number