Kenmore Washing Machines - Page 9 - Recent Questions, Troubleshooting & Support
KENMORE WASHER 110 27802690 NO HOT WATER?
This has probably already been done, but often debris from the hot water line will plug the screen that is at the inlet. this is often a rubber washer with a screen molded into it. scale from water heater and lines builds up and cuts flow way down this video gives an example. https://www.youtube.com/watch?v=xED_4n5e_ww
HE4t Elite F02 error code
its the error code for a long drain time most likely you need to check the filter in your pump for obstructions
First if you have a wet vac pull the drain hose out of the drain spout and use the vac to pull the water out of the washer through the drain hose.If not you will need a pair of radiator hose clamps from the auto parts store. Pull the screws from the lower panel at the front of the washer and remove it.in side you will see a rubber hose coming down from the tub to the drain pump. Put the radiator hose clamp there if you didn't have a shop vac.On the front of the pump is a round part with a handle turn that and remove the pump filter .Clean any foreign objects out of the pump and look inside the pump to make sure no impeller blades are broken if any are you will have to replace the pump. put the filter back in and tighten it. If you had to use the hose clamp remove it now.reassemble and don't forget to give the tech his four boxes if this fixes it
My Kenmore Elite he5t steam washer is about 2yrs
F35 is a water level error.
The water level switch (pressure switch) has malfunctioned.
If you remove the top panel, three screws in the back, you will have access to the pressure switch.
With the tub empty, remove the vinyl hose from the switch and blow backwards through the hose to clear any restrictions.
If the fault codes return after doing this, you will likely need to replace the pressure switch.
Also - please be sure to use He soap.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.^@$$
Top load washing machine will not agitate
You may need to replace the agitator cogs, aka "dog ears". They allow the agitator to work in a ratcheting motion. I have a different washer but have had to replace mine several times. They are plastic and just wear down.
Not finding what you are looking for?