Kodak ESP - Popular Questions, Answers, Tips & Manuals - Page 9
Kodak 5210 all in one was working fine but all of
If you detect a burning smell, it's time to unplug the printer and replace it. Always unplug immediately whenever you have an electronic device with a burning smell as a matter of safety. As Kodak no longer makes inkjet printers, you will need to select another brand.Hope that helps,Bax
How to unclog a unused printer cartridge
For your Kodak printer, you can follow the same procedure used for the HP Photosmart and Officejet printers which have removable printheads...just perform a quick 2-minute hot water flush on it: 1. Remove both ink cartridges. 2. Remove printhead (depress grey tab and pull out).3.
While the
PRINTHEAD is removed, perform a hot water flush on the PRINTHEAD assembly:
Flushing
Procedure:
http://inkjet411.com/?page_id=2412
a.
Over a sink, run warm tap water directly
into the ink ports for approximately 2 minutes - this will effectively
saturate the foam ports and blow ink out/thru the nozzle plate bottom.
b. Using a lint-free towel, remove water from
rear/bottom electrical contacts. Ensure printhead electrical contacts and
exposed surfaces are fully dry.
c. Install the printhead into the printer. You
may observe a "Replace Printhead message" so you will need to cycle printer
power by turning printer off and then on to clear the error.
d. Install ink cartridges and retest printer.
You should observe a New PRINTHEAD alert message followed by an approx.
4-minute preparation countdown prompt.
--- If you have reached this point of the
troubleshooting and all the previous troubleshooting steps did not work, then
the printhead is likely damaged or at end of life* and may need to be replaced. For information
on North American ink refill services (HP, Epson, Canon, Lexmark and Dell) at a major retailer near you (should you
wish to save ~50% on ink costs), general printing problem resolutions or advanced printer diagnosis procedures (advanced cartridge diagnostic tests/cartridge error
bypass & printer reset methods, etc.), please visit Inkjet411:
http://www.inkjet411.com
Printer not recognise new wilko ink cartridges
This model printer may only let you use genuine
Canon/Epson printer cartridges. If you try to refill these ink cartridges it
will not work because the has an embedded chip in the
cartridge that detects the empty cartridge even though it has been refilled.
Parts repairs
check cable connections, settings, printer installed ok. power up
How to scan pictures to email
You cannot scan pictures directly to email.Scan the photo and save the photo as a JPG file.Open your email program, setup the email and address to your friend and then attach the scanned JPG file to this email before sending it.
CANON IR2520 SHOWING ERROR CODE 804
In my experience the 804 error code relates to the location/availability of a file. If you are trying to print/access a particular file check the path and make sure you have permission to access it.
12/28/2012 11:31:59 AM •
Kodak ESP 3...
•
1,718 views • 2 helpful votes
Kodak 3.2 ESP has an error clear all paper code 3528 but there is nothing there
Turn off the printer and unplug it. Open the top access panel. Inside on the left you will see three round, white gears. Rotate the gear closest to the front back and forth with your finger. If any scraps of paper appear near the rollers, remove them. Close the top access panel. Plug in and start the printer. This worked for a Kodak ESP 3.2.
Not finding what you are looking for?