Konica Minolta bizhub - Recent Questions, Troubleshooting & Support
What is error c2151?
Open the right side door. on the door you will see a sponge looking roller that roller is on the back side of the paper. On the front side is the Transfer belt which is inside the machine across from it when the cover is closed DO NOT TOUCH THE BELT THE SHINEY LOOKING THING THAT gets nicked or damaged you will see it on the print. Any way the code is for the sponge roller check and make sure it is installed properly, two levers at each end lock it in place. the whole assy. that the roller is on has a motor system that could also me a problem. If that roller is OK was it replaced when the belt was replaced? If not get a tech to look at it. Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/normanj_7893313f0751935f
SC46-08
An abnormal speed signal of the paper feed motor (M4) is checked. An error detection signal is detected twice in succession
I have a konica minolta c8000 with error code c3106, what does it mean?
Open the mid section of the copier and pull out main section. Then re-install. The code mean the the fuser (The large device on the left hand side that melts or fuses the toner to the paper is not connecting properly to the electrical connections in the back where it plugs into. Could be that the connector is broken because some slammed the mid section to hard. Or that you need to give the section a better/some what harder push when you close it. Might want to remove the FUSER unit and put a flashlight to the back make sure the connector is ok and check the connector on the fuser itself!
What is error c2557
What is the model number? Ball park! replace the black developer unit and black drum
Not finding what you are looking for?