Kyocera Mita Office Equipment & Supplies - Page 9 - Recent Questions, Troubleshooting & Support

Vertical transport unit has to be removed and cleaned or replaced. Not fun.

On which machine?

Has to be done in service simulation 917 with a USB stick.

Specify the type of paper you are using in driver preferences.

Press and hold the following buttons in the sequence below. (1) Stop/clear, (2) start, (3) exposure lighter, (4) exposure darker, release the 4 buttons and press the stop/clear button again. the display should now indicate 000. below the display are 3 buttons... press the left button once, the middle button 6 times, and the button on the right 3 times. the display should now indicate 163.... press the start button 3 times. your machine will now restart, and if the code was as a result of a power problem, should now work fine. if not the problem could be related to the fixing unit, power supply, or one of the boards. Also do not tamper with any settings while in the service mode, this WILL have undesired effects. TAKE NOTE, this will only work if your model is the KM-1500

press and hold the following buttons in the sequence below. (1) Stop/clear, (2) start, (3) exposure lighter, (4) exposure darker, release the 4 buttons and press the stop/clear button again. the display should now indicate 000. below the display are 3 buttons... press the left button once, the middle button 6 times, and the button on the right 3 times. the display should now indicate 163.... press the start button 3 times. your machine will now restart, and if the code was as a result of a power problem, should now work fine. if not the problem could be related to the fixing unit, power supply, or one of the boards. Also do not tamper with any settings while in the service mode, this WILL have undesired effects. TAKE NOTE, this will only work if your model is the KM-1500

Try updating the firmware, if it does not work you need to replace the panel. but most of the time firmware fix this issue. I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

where you located? I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

The optimizing performace may be because of the temperature in the room.Clean out all filters in the machine.Do not reset the drum light unless you do change the drum as the copy quality may degrade.

The default code for the Kyocera KM-2050 is 6482.

c6000

sounds like the rollers that feed the paper in is dirty or is completely worn... clean with rubbing alcohol and clean cloth I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

Firmware is not available on line! That is property of the company they only give out o authorized dealerships and corp techs, you will need a tech to re-flash the firmware. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

clean the LASER glass for that color, if you dont know what that is get a tech out. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Abort Code recommended you have a tech come and re-flash the copier firmware. Firmware is the copiers Operating system not a driver. Firmware is only available thru secure server available to dealerships and KMBS Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Check the settings in your printer program ... control panel - printer - select yours and look among the tabs for the solution to your problem

MAYBE, you have a Spanish print driver ... In that case, go to the manufacturer web site and find the English version.