Maytag Ovens - Recent Questions, Troubleshooting & Support


if voltage to transformer see if after to board if ok bad board if no bad transformer

Maytag Ovens | Answered on Apr 30, 2019


Usually a failing capacitor on the board to the display.

Maytag Ovens | Answered on Mar 03, 2019


You either have a bad control board or the touch pad has a button sticking and it needs the touch pad. The temperature sensor would not be a problem for this concern. I hope this helps.

Maytag Ovens | Answered on Feb 19, 2019


Either a bad connection or the motherboard wasn't the problem.

Maytag Ovens | Answered on Feb 18, 2019


Just a guess but the igniter may be defective even though new

Maytag Ovens | Answered on Jan 19, 2019


Hi Janine.

F3 means "Shorted oven temperature sensor" and it is returned when the oven electronic control detects a wrong impedance value from the oven temperature sensor circuit.

The oven temperature sensor is a probe located inside the oven cavity. The sensor can be removed from the oven and tested using a multimeter set on impedance. The impedance reading across the two sensor's contacts at room temperature must be about 1100 Ohms. Impedance increment rate is 100 Ohms more for every 50 degrees temperature increase. If the reading is sensibly different from this value the sensor must be replaced.

Here the replacement part:
Long Oven Sensor Kit

The sensor is indicated as part number 11 in the exploded view available here.

The sensor is held by two screws. In order to replace the sensor disconnect power, disconnect the connector attached to the sensor, undo the two screws and remove the sensor. Perform operations in reverse order to install the new sensor.

Regards.

Ginko

Maytag Ovens | Answered on Dec 27, 2018


The F7 error code indicates that there is a problem with the buttons of the control panel. The code comes on when two or more buttons are stuck at the same time. The oven cannot operate when this condition exists. The oven is repaired by replacing the control panel with a functioning one. You may try to tap on the control panel lightly to see if one of the ttons is stuck down.

Maytag Ovens | Answered on Dec 19, 2018


BETTER CALL A MAYTAG REPAIR SERVICE TECH .

Maytag Ovens | Answered on Dec 12, 2018


The F5 E2 alert indicates the washer can't engage the lid lock because there may be an obstruction in the lid lock area.

Please check the lid lock area and remove any objects in that area. Also verify there are no clothing items in the way.

Maytag Ovens | Answered on Oct 19, 2018


have a technician check for failed elements or faulty oven switch

Maytag Ovens | Answered on Oct 06, 2018

Not finding what you are looking for?
Maytag Logo

1,071 questions posted

Ask a Question

Usually answered in minutes!

Top Maytag Ovens Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Paul Carew

Level 3 Expert

3480 Answers

Brad Brown

Level 3 Expert

18121 Answers

Are you a Maytag Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...