Maytag Logo

Maytag Popular Questions, Answers, Tips & Manuals

Do you work here? Claim your company

  • 2K Products
  • 163K Answers
  • 3M Views

i don't know. most dryers come with a chart showing what wires are for. green is usually used for ground but read
your chart. few have chart with owner's manual and most i have seen are in a clear plastic bag stuck on the back or
stuck in the open area under the tub.

Maytag Dryers | 55 views | 0 helpful votes


If there is a LOCK button hold it down for 15 seconds

Maytag Washing... | 34 views | 0 helpful votes


Don't try to fix it yourself it could cost you more in the long run but if the shaft isn't turning the propeller more than likely there is something in the pump stopping it like a small sock for example call a repair tech worse case is u need a new pump

Maytag Washing... | 55 views | 0 helpful votes


Well I just changed the capacitor on my washer. It would fill with water and stop. My first thought was lid switch it checked out good. Next timer but usually if you switch to another type wash cycle it did not work so I thought timer must be good. I tried to get it to pump out so I pulled pump off shaft and it turned free( I have direct drive to pump no belt) Two metal band clip on to hold pump and motor shaft turned free. I then checked capacitor it would not charge and was not storing charge. The capacitor can shock you very bad do not touch metal connectors till you discharge stored voltage. I dropped water level by just putting end of drain hose in five gallon bucket I had to dump several buckets. I ended emptying by scoping water out with big plastic cup into bucket. I have no bottom on my Maytag so I just leaned it against the wall to get to pump and capacitor. A couple times when I tried to start with washer full of water, I would hear a buzz sound at bottom but not every time. Washer has been working great for 2 weeks now. Make sure to unplug washer before working on it.

Maytag Washing... | 42 views | 0 helpful votes


call maytag repairman

Maytag Washing... | 34 views | 0 helpful votes


the oven that wont work see if ignitor glows at pre heat if not and voltage to it replace ignitor

Maytag Ovens | 40 views | 0 helpful votes


U should just use your normal setting wash in warm water rinse with cold I've got 30 yrs appliance repair exsperiance washers were my specialty

Maytag Washing... | 40 views | 0 helpful votes


Most likely a bad main board. If you have the model info, i could possible over more details, thanks

Maytag Washing... | 24 views | 0 helpful votes


Go to www.repairclinic.com and enter medb835dw4. With luck, you will be presented with a list of replacement parts/assemblies and may be able to view a generic Maytag video showing disassembly.

Maytag Dryers | 32 views | 0 helpful votes


F04 E04 means low power voltage to dryer - check both sides of AC receptacle for 110 to 120VAC on each side to ground - check breaker panel for tripped or bad 220VAC breaker. Only one side may be suppling voltage to dryer.

Maytag Washing... | 23 views | 0 helpful votes

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Maytag Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Brad Brown

Level 3 Expert

18139 Answers

Cindy Wells

Level 3 Expert

6063 Answers

Are you a Maytag Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...