When your freezer is displaying an SH error code on the temperature display screen, it means that the freezer temperature sensor has shorted out. To troubleshoot this problem, you will need to start by disconnecting your refrigerator from its power source and locating the freezer temperature sensor.
Sept 6, 2022
If your Maytag Centennial washing machine is making a sound like it's draining water even though there's no water in the tub, it could be an issue with the drain pump. The drain pump is responsible for removing water from the machine during the spin cycle.
Here are some steps you can take to troubleshoot the issue:
Unplug the washing machine and remove any remaining water from the tub manually.
Check the drain hose for any kinks or blockages. If you find any, clear them out.
Remove the drain pump from the washing machine and check for any clogs or damage. If you find any, clean or replace the pump as needed.
Reinstall the drain pump and run the washing machine to see if the issue has been resolved.
If these steps do not solve the problem, it may be necessary to call a professional repair technician to diagnose and fix the issue.
Hi,
Please power cycle the dryer and the turn the dial 90 degrees in the opposite direction of the the usual direction that you'd use to set a cycle. Then try to use the dryer again.
Thank you.
If the baking element stays on even when the oven is turned off or when it's set to a different temperature, the issue might be with the relay board. The relay board is responsible for sending power to the bake element when it's supposed to be on, and cutting off power when it's supposed to be off.
To confirm if the relay board is the culprit, you can try the following:
Turn off the power to the oven at the circuit breaker.
Remove the back panel of the oven to access the relay board.
Look for any signs of damage or burning on the board.
Inspect the connections and wiring for any signs of damage or burning.
Use a multimeter to test for continuity across the contacts of the relay board that control the bake element.
If the continuity is present when the oven is turned off, or if the board is visibly damaged or burnt, then it's likely that the relay board needs to be replaced.
If the relay board is determined to be the issue, it's recommended to have a qualified technician replace it as working with electrical components can be dangerous.
Hi,
Please reload the washer with dry clothes and attempt to wash them as normal. If the weight is distributed evenly, then the unbalanced-signal should go away once the wash starts.
Thank you.
Hi,
the error relates to a motorspeed sensing error. I would advise you to get the washer serviced via maytag since there are multiple portions breaking down. You can call Maytag to get this done and learn about the actuators potential links to the machine's issues: 1 (800) 344-1274
Thank you.
The electronic control panel and board has detected a runaway in the temperature and the control board and the heating sensor could be broken on your dryer and need to be replaced.Or the circuit breakers may need replacement then.
Hi,
you might reach out to a third party dryer manufacturer and ask them if they can provide the part that you're looking for. You might start by looking through white pages or calling 411 to find such a company. Thank you.
You will have to call a person that repairs major appliances to have a look and see what the problem is. There could be something wrong with your washing machines controls for the door not to open at all. Or the door latch could be the problem and the motor.