Neptune washer ballasting water
No, drain it. Just remove the drain hose from the clip at the rear and low the hose into a pail or cooking tray. Gravity will do the rest. Make sure it is always kept upright unless you have the transport brackets.
Maytag Wall Oven MEW5530DDB, elements not getting fully red hot, elements continuity is good, replaced heating sensor, elements not getting RED hot as they use to be.
Check the voltage to the oven. Also, check the contacts on the oven relay. (If the relay shows signs of having been overheated, the contacts are probably bad, but not every bad contact will cause visible overheat damage.)
Inspect all of the connection terminals in the wiring from the inlet power to the controller relay to the heating elements. A poor connection will overheat the wire but prevent proper heating of the element. Heavily oxidized or loose terminals should either be cleaned up or replaced. Since you say both elements have the problem, I would start first with the input power connection. That includes turning off the breaker to the oven and checking the wall socket.
If you have aluminum wiring to the wall socket, the connection may need to be redone. First verify that the socket is marked for aluminum wiring (Al or Al/Cu). Aluminum wire connection requires great care: the wire must be cleaned to expose shiny metal, then immediately coated with a special grease made for aluminum wiring before insertion into the socket terminals, and the terminals must be torqued to specification. Otherwise, you will eventually have a poor connection and possible fire hazard. If you don't see any grease on aluminum wire, that could be the problem. If you have copper wire, standard wiring procedures apply.
7/31/2022 5:41:38 PM •
Maytag Ovens
•
66 views • 0 helpful votes
My Maytag Bravos top load washer upon spin cycle shakes so bad that it shuts itself off in less than ten seconds. It's level, true level, clothes are evenly distributed and not too many?
One or more of the tub suspension rods or dampening straps could be damaged. Does the tub bounce smoothly, if you push it down and then release it? This checks the suspension rods. Other parts related to balancing the tub include the suspension pads, springs or balance rings. (The washer will usually squeal and shake badly, if the tub bearing is failing.)
The washer shuts off to avoid damage additional damage to the washer.
I hope this helps. Please add a comment with the model number of the washer, if you need a parts diagram to show where to look for these parts. The model number may be on the machine in one of these places: on the back behind the control panel, inside the lid on the bottom right corner, or on the back of the washer on the base frame on the left.
Cindy Wells
RED Control Lock won't reset.
Is this for the Maytag Maxima, or something else? All questions should have 'make model (what it is)'. We see 75% of questions posted to the wrong categories.
The easiest way to reset a Maytag washer is to disconnect the power to the washing machine for three minutes
. Disconnecting the power allows the electrical charge to dissipate from the washing machine, which allows it to reset. If the reset fails, unplug the washer again, this time leaving it unplugged for ten minutes.
Dec 2, 2021
More here
https://www.google.com/search?q=maytag+maxima+mhw6000+resetting
..
Not finding what you are looking for?