Maytag Neptune - Popular Questions, Answers, Tips & Manuals - Page 8
Why the water wont come in the washer ,and the door stayed lock
Because the cycle hasn"t get to the point yet were the water need to pump in to the washer so you have to leave the washer on to work it self. u might have mistakenly stopped the washer yourself after u turned it on or something else is wrong and u have to give us some more info on what's going on . Now let just try this and see if ur washer will work.
Let restart the whole process again, the normal way u start ur laundry,
1, Turn washer off ( Like you're done washing )
2, Now put a new load into the washer, check all button to make sure they are in the right position then turn washer on.
Still not working. Then we need some more info or you need to call someone to take a look at it .
Error code 06 F or a nepturne washer
the 06 code refairs to motor problem or mcu control board,i assume the machine is not turning this is because a wire has come apart from the motor, or the mcu board needs replaced as it can no longer read the signal from the motor.adrian,,,,
When I push "Start" on my Maytag Neptune front load combo, it lights up, the door locks, then it starts filling and after few secs it cuts off, what can I do?
If this is a combination washer dryer (model number starts with MLE). First disconnect the power to the unit and locate the main control board located on the top right hand corner. You can remove the two 5/16 screws holding the top of the front panel and move the front panel forward to remove the other two 5/16 screws holding the front of the top panel. Once these are removed there is one more 5/16 screw holding the board in place, remove the screw. Now lift the top panel and pull out the board with the wire harness. Search for the resistor R11 on the board (it's towards the middle). If this resistor is burnt, replace the main board and the wax motor located inside the latch mechanism ( it will have a red/burgundy color plunger which will be replaced with a wax motor with a black plunger). If R11 is intact, look closely at the latch system, and replace it if needed.
Ny front load neptune washer comes to the spin cycle and the door unlocks and it won't spin or empty the water. Is it the inlet valve? Or what?
Janie,
It sounds like your evacuation pump is clogged, and needs cleaning or needs to be replaced. Some front loaders have a clean out in the front lower left of the machine 's cabinet. You'd need to check with your mfg owners manual to see if your model has a clean out for the evacuation pump which pumps the water out of the machine.
Old rubberized bathroom carpets, and other fraying items like towels torn into rags, can lose enough material to clog up the pump impeller or freeze it until the motor burns out trying to turn against a bunch of foreign materials like these.
It's a nice washer and worth the repair and note of caution once you get it fixed.
Cheers,
Kelly
Commercial and Residential Facility/Property Manager
San Diego, CA
Not finding what you are looking for?