Mitsubishi WD - Recent Questions, Troubleshooting & Support

1 Answer

I need codes for Mitsubishi 82. Model WD-82738 Serial 311546

https://www.manualslib.com/products/Mitsubishi-Wd-82738-607049.html

Mitsubishi... | Answered on Oct 30, 2019

2 Answers

Timer flashing

remove the lamp and check to see if its ok, if ok replace lamp thermal sensor

Mitsubishi... | Answered on Oct 10, 2019

1 Answer

Fixing 3 white dots on mitsubishi wd-60737

My guess is that it is not economical to fix as it needs new screen. Unless it's under warranty but then you would not be asking. I had an off brand tv that I sold at my Radioshack franchise year ago. I had a customer get a tv with one white pixel constantly on. I replaced it for him. When I called the mfg, they informed me that this was allowable error in the b grade displays they used in their TVs. I quit selling them and put the bad one in my Rv. Still ticked me off when I watched it

Mitsubishi... | Answered on Oct 02, 2019

5 Answers

Mitsubishi HD 1080 wont turn on now

did u by any chance open the assembly of the tv and touched the pcb board... the circuits on this board r very delicate and u shud be very if u r handling tis....

wen u switch on ur tv r u able to listen to any sound or wat?
if yes reply back, i wil help u

Mitsubishi... | Answered on Jul 25, 2019

0 Answers

I have a mitsubishi wd-82837 with a display issue. There is a band at the top of the screen where the color is off. It is a little bit darker that it should be.

Mitsubishi... | Posted on May 28, 2019 | Be the first to answer

1 Answer

I have a Mitsubishi 73" tv WD73837. When I turn the tv on, On the right side in vent it's very loud I unplug the tv, it wines down and stops. Could it be the cooing fan or? Thank you so much, Gloria

Yes it is. It's a cheep fix. The fans are on ebay. If you have the manual for the TV. Look in the specs for the TV and locate the fan. You will see the voltage and rpm of the motor. Most likely it will be a 12v dc fan. It has two to four screws holding the fan. And a small plug. I hope this helps you in some way. THE CB SHOP OF COLEBROOK NH. Via Facebook.

Mitsubishi... | Answered on May 18, 2019

2 Answers

Turns off shortly after turn on

try blowing out the set and especially the three fans and the area around them---seen a number of these where a dirty fan will slow down just a little and even stop set from coming on at all or shutting down sometimes.

We usually roll them outside and with a aircompressor clean the set out, it usually looks like a dust storm.

I have had more than a few brought in that would not power up and as soon as cleaned outside, came up and worked.

The actual air intakes are on the front of the set and dust gets sucked into the unit.

Mitsubishi... | Answered on Apr 05, 2019

1 Answer

Wd-y577 error code 3 4

check out steps-by-step guide to fix error code 3-4 at:
https://mslivesupportchat.blogspot.com/2019/01/error-code-3-4.html

Mitsubishi... | Answered on Feb 12, 2019

0 Answers

Mitsubishi Model 65735 Rear Projection picture dim. Replaced with new bulb. Still Dim.

Mitsubishi... | Posted on Jan 07, 2019 | Be the first to answer

1 Answer

WD-62525 green timer light keeps blinking after lamp replacement

Did you let the green light flash for about 70 seconds? It goes thru a self check when plugged in and takes a little time

Mitsubishi... | Answered on Jan 04, 2019

0 Answers

Wd-73733 mitz dlp: Where does the thermal sensor plug in?

Mitsubishi... | Posted on Dec 23, 2018 | Be the first to answer

0 Answers

Mitsubishi 82838, one blinking red, 7 blinking yellow

Mitsubishi... | Posted on Dec 07, 2018 | Be the first to answer

0 Answers

Resetting a Mitsubishi WD 73638 TV but I do not have the PIN. I tried holding down the guide and format but that didn't work.

Mitsubishi... | Posted on Nov 18, 2018 | Be the first to answer

1 Answer

Does not power up

Did you check the caps on the power board when you had it out?

Mitsubishi... | Answered on Nov 16, 2018

1 Answer

My picture has gone dim on my wd60753 that is 5

YES

Mitsubishi... | Answered on Oct 15, 2018

0 Answers

I have a Mitsubishi WD-82837. I was watching TV when I heard a rather loud POP. I imagine that when I open it up, I'll see a blown cap. Is this a power supply, or is there a cap bank/board?

Mitsubishi... | Posted on Oct 15, 2018 | Be the first to answer

0 Answers

My Mitsubishi TV when you turn it on has a faded picture and no sound Model # WD-65736.

Mitsubishi... | Posted on Oct 11, 2018 | Be the first to answer

0 Answers

I need to know where the capacitor goes in a Mitsubishi tv model WD-73638

Mitsubishi... | Posted on Aug 13, 2018 | Be the first to answer

2 Answers

Mitsubishi dlp tv picture is getting darker

One of two possible issues:

1. Lamp is nearing end of life and may dim just before total failure.

2. A few of these models have 2 mirrors(check with Mitsubishi to see if yours is one) A large mirror in back (never gives a problem and do not try to clean it. Some idiot in these sets used a small mirror inside that the optical unit shines the picture into (wedge shaped mirror and small) and it is facing up----the fans intake air from the front of the set around this mirror--it gets coated with lots of dust---Picture can loose up to 70% of its brightness and clarity if that mirror is dirty--looks like 20 year old set .

If you do not wish to check with Mitsubishi GOOGLE THE MODEL NUMBER with "mirrors" to see.

If it has 2 mirrors I can tell you exactly how to get at it.

SD TECH

Mitsubishi... | Answered on Aug 06, 2018

0 Answers