Nautilus Exercise & Fitness - Page 6 - Recent Questions, Troubleshooting & Support
Startrak 950 orbit treadmill
ERR1
indicates a speed issue. In this case, the motor speed as reported from the
optic sensor differs
from the
speed setting.
Analysis:
Optic sensor signal issue -- Either the optic sensor signal is not right, or it
is read incorrectly, or
the signal is not reaching the display.God bless you
6/4/2013 11:15:01 AM •
Nautilus...
•
Answered
on Jun 04, 2013
Calibrate nautilus T914
The Steps for Newer
Style Console Calibration:
- Locate
the calibration area on the rear or underside of the console (a hole, near
the console's center, that goes through to the electronics board. (This hole should not have a screw in it.)
- Insert a pencil (eraser
end), into the hole and feel around for the cal button (will click
when pressed).
- Press the button 2
times (with the pencil eraser). The first click should show
CL11 in the console, the second click should show CL21.
- If the process was done
correctly, and CL21 appears in the console, you are in
"calibration mode." The next few steps consists
of pressing buttons on the console and observing settings. This will not require any other tools.
- Press ENTER. CL22 should
display in the TIME window and (??) in
the SPEED window.
- Press ENTER. CL23 should
display in the TIME window and (??) in the SPEED window.
- Press ENTER. CL24 should
display in the TIME window and (??) in the SPEED window.
- Press ENTER. CL25 should
display in the TIME window and (??) in the SPEED window.
- Press ENTER. CL26 should
display in the TIME window. You should then see the letter
"E."
- Press ENTER. You should see
"SS" or "55" in the console.
- Push the STOP/START button. For
safety, at this point, you should step off, or be off, the treadmill.
- Push the ENTER button. The
walking belt should start to move, accelerate to maximum speed, then stop
on its own.
- When the belt stops, the
incline should self test by raising to its highest incline
position, then lowering back down to its lowest position.
- Once
the incline test is complete, push the POWER button 2 times. The unit
should shut off and the console should go completely blank. If this
happens, the treadmill is done calibrating and is ready for
use.
If the letter "F" appears in the SPEED
or INCLINE window when the power button is pressed 2 times, the treadmill
is indicating a failure somewhere either in the SPEED or INCLINE
(depending on the window the "F" appeared in). Troubleshooting
the failure would be the next step. The Calibration seqGod bless you
Not finding what you are looking for?