Premiere Microscopes Science & Laboratory - Page 9 - Recent Questions, Troubleshooting & Support

failure in door switch...replace or adjust...

Visually check for obstructions on the door seal area. Clean gasket and its mating face. Run Cycle again.

It means it was unable to achieve sufficient vacuum to hit whatever set point you have it set for. It also probably means a) you have a leak in the chamber or b) the device creating the vacuum may be clogged or broken.

Replace the wire..

See if there are no steam leak.

See fuses...

Clean the chamber with 50x50 water and vinager whith a cloth once a month.

What is the problem?

What model?

It could be several problems.

Failure in power suply or electronic unit.

See if you have power in the electronic unit.

Need Mgfr.,model# Art.

What is the alarm? What phase of the cycle are you getting your alarm?

Autoclaves sterilize devices by subjecting them to high pressure saturated steam at 121 degrees Celsius (250 degrees F) for at least 15 minutes

117 degree's F or C? If set to Fahrenheit then that's about right. If set to centigrade then look for leaks. What type of unit are you using?

you can try replacing lcd, if that does not fix problem then send it in for service

most cameras work with any windows version. there are also special microscope-camera-programs you can download for your camera. I would not worry about the software.