Rowenta Irons - Page 2 - Recent Questions, Troubleshooting & Support

How to replace the fuse on Rowenta DG5030? Please help..

They are built to shut off after about 30 sec or so if the iron is not moving and the iron is in pressing position (sole plate down). They shut off if they are not moving and standing with the sole plate vertical, in about 5 minutes. If you move the iron (like ironing) they reheat. If it doing something else the electronic control is defective. It is cheaper to replace than repair.

Similar models manual: https://www.rowentausa.com/instructions-for-use/Products/Linen-care/Steam-generator/Compact-Steam/csp/1830006489 https://www.rowentausa.com/instructions-for-use/LINEN-CARE/STEAM-STATION/COMPACT-STEAM-STATION-DG7530/csp/1830005479 https://www.rowentausa.com/instructions-for-use/LINEN-CARE/STEAM-STATION/PERFECT-STEAM-STATION-DG8520/csp/1830005299

I'm on my fifth Rowenta iron. The first four eventually started to leak. I keep buying Rowenta because I get the best results except for the leaking. I've been using filtered water even though the manual sas to use tap water. I will start o use tap water. The fifth one I bought was highly rated by Consumer Reports. If this new one starts to leak, I'll bring it back and buy a different brand.

https://www.rowentausa.com/consumer-services/contact-us https://www.rowentausa.com/consumer-services/warranty-and-repairs/repairers There does not appear to be an official repair center in Nebraska. Contact the manufacturer using the links above to request assistance, please.

need a meter and check the unit for short

on of switch not working

There is no repair parts so replace it

Hi,

Attached below is the Rowenta website to obtain PDF copies of the manuals. If the hyperlink does not work, cut and paste it into your browser's address line. There are also links to download Adobe Acrobat Reader to allow you to view and print the documents if you do not have this program. Please advise if you find this helpful...
http://www.rowenta.com/rowenta/frame.aspx?page=http://www.rowenta.com/rowenta/consumer_care/use_n_care/downloadInstructions.aspx?RblCategory=Download

Pour in some vinegar (half) and some water (half) in the machine. Turn it on and let it run a bit. Make sure to do it outside since it smells badly. After that, rinse a few times before use.

Ok. This thing is caused by scaling. If the steam generator runs out of water the sensor thinks the tank is empty and causes the machine to go to standby (basically switch off -- orange light comes on). The solution: Open the machine and clean it.

MAKE SURE THE POWER CABLE IS UNPLUGGED BEFORE ATTEMPTING TO DO THE FOLLOWING:

1. There are six screws ( phillips - you will need a long screwdriver). Two of them are hidden under the wheels (just pop off the rollers and you will see the screws)

2. Open the steam generator (there are four screws) and be very careful with the 'O' ring -- you damage it and you can say good bye to the machine. Clean it if you see scaling. The amount of scaling present would indicate how hard your water was. This itself may not be cause of the problem but now that you openend the machine, you might as well as clean it for better efficiency.

3. Disconnect the hose to the steam generator (it has two circlips) and clean it. Mine had hard deposit of scales preventing the water reaching the steam generator.

Re assemble it.

Good Luck

Alex0714

You can probably buy them in a set. I’m sure one will fit.

There is pcb manufacturer RayMing, you may visit it https://www.raypcb.com/ and to choose your specific PCB

White vinegar

It was on the box it came in.

there is a reason for the wire shorting at that point could be a dead short that caused the wire to burn or other serious problem best advice is to take it to an appliance repair shop for a diagnosis and quote or to be safe simply junk it and get a new one

Be sure the voltage and current you are using in India is correct for the unit. Is the power on the unit switchable?

It is evidently defective. If this was the first use, box it up and send it back for a refund or replacement. Most companies require to issue a return authorization form before shipping it back.

Jim , please check this video you can able tofill water. Rowenta Steamforce Iron