Samsung Dryers - Page 8 - Recent Questions, Troubleshooting & Support

Get solution for this online at www.reliable-store.com and get complete guide on whether to repair or not, service it, and how to repair etc

Well, is it when your load is done? then it starts back up again and makes the noise?... If so, it's the wrinkle reducer feature, you can turn it off. Hope I helped, Mike

Have you tried unplugging it for 10 minutes to see if it will do a hard reset?

It's possible if it was plugged you could have burnt something out. You don't state whether it's an electric or gas dryer. i say to get a professional person to check it out. That may be cheaper in the long run.

Your idler pulley has most likely failed causing the belt brake switch to be activated. Samsung Dryer Idler Pulley Roller Replacement DC97 07509B

sounds like the capacitor its down in the bottom of the dryer looks like a large fuse

my best advice to not buy samsung or lg appliances

there are two jumper wires,put one from the bottom of the middle t-stat and the other end to the heater,put the other jumper from the top of the middle t-stat to the back t-stat,put the long red wire to the heater that comes from the motor and the other wire and that's usually a long blue wire from the board to the back t-stat,he should have left it all connected until the new part came in so you don't loose any screws and you don't mess up any of the wires.

sounds like the heating element is faulty and should be replaced

The drive belt is either broken or the belt tensioner spring is broken.

you are to replace the heating element

Replace the heating element

Heating elements are off. Replace them