Simpson Washing Machines - Page 10 - Recent Questions, Troubleshooting & Support

Then either the cold water inlet valve is faulty or the main board is not supplying power to turn valve on. Use a multi meter to test which it is or get someone out that can.

Yo, David! Please see this old 2010 FIXYA post ~ I may help you to the right path! Simpson enduro 702 want to replace the bearing and seal that holds the... Anthony

tyr a 10mm or 12mm socket

too much powder in use and not enough water in the wash change over to liquid detergent and save the machine and hoses

check for a blocked drain pump

Either power on/off switch is faulty or main control board has a fault and may have to be replaced. You need a test meter and fault finding knowledge to trace the fault. Probably best you call out a service person.

use a drain cleaner to remove the soap and gunk build up in the sink section

yes go to the manufactures website and download the user manual and look in the trouble shooting guide for a possible answer eric