Simpson Washing Machines - Page 7 - Recent Questions, Troubleshooting & Support

If they are screw in feet, you need to buy other feet which have a bigger thread on the stem and drill/taper the new holes on the bottom of where the old feet were. If it's just glued on feet, then clean the plate and the foot and glue them back on.

Request from manufacturer or Google

Suspension rods or shocks depending on design.

Sorry not able to read minds or see what is happening from so far away. You need to post a full description of what happens and when exactly it happens and what you can or can't do after i.e. does power come back on by itself or if you switch it on. The more info the better.

What about it? So you have a problem that needs sorting or what? We unfortunately are not mind readers. Sorry.

sounds like the bearings have gone,major job

Draining problem. Pump blocked or failed. https://www.simpson.com.au/support/troubleshooter/?q=cat1

remove top panel and there is a fuse on the board test fuse if good then probably a board fault

the fuse is usually attached to the board is good yes board

check the power switch with a meter otherwise if not that then a board fault if totally dead

u need an allen key and hammer to break them free

try replacing the capacitor located under the control panel

Maybe the valve in the internal softener?

Usually has a securing ring just under the arm. Turn it quarter turn & arms comes off. If no ring to turn then arm will just pull straight off.

Maybe pulley loose underneath.

The rubber transmission belt is broken.