Tissot T - Recent Questions, Troubleshooting & Support - Page 2

This is the tried and tested solution from this very nice gentleman. Many thanks to him (Ha Bi):

1. Press and hold on to the T button until it beeps
   
2. Touch the middle of the screen to change digital display to unit selection
3. Press and hold the T-button until "Synchronize" comes up in the digital display
4. Use the + button and - button to align the hour and minute hand to 12:00.
5. Click on the T-button again. Congrats, you're done!
6. Enjoy~

Must see blog for all T-touch users

http://myhabi.blogspot.com/2008/10/tissot-t-touch-battery-change.html

This is a Myth my friend.Anyone can change a battery on Tissot T Touch.The First models have 2 steps the Battery Replacement and Synchronization.After the Tissot Expert add the Reset as third step. In my blog i have instructions with video how can you do that. www.watch4maker.com

If the functions dont work from moisture I can repair it. if the sensor damaged the watch is unrepairable and only the swatch group service center can repair this watch.please check my Blog i have many posts about these problems for all Tissot T Touch Series Watchmaker Video Review For Watchmakers and Watch Fans

Hi,You can try to so the synchronization to match the digital time and the analog hands.here are the step by step procedure including visuals, click on the link.I hope this will resolve your issue.Thank you for choosing Fixya.

Push the middle button then touch the centre screen selecting the "nits" mode(24 C m), then push the middle button again for 5 seconds."Synchro" will appear on the display. By using pushers + and -, bring the two hands pre-cisely to 12 o'clock Incrementation of the minute hand(3 steps=1 minute) Incrementattion of the hour hand(3 steps=1 minute) Press the middle button to validate the setting.

here is manualhttp://support.tissot.ch/usersmanual/138-en.pdf

There is a solution, but you have to wait a bit. I'll contact Tissot tmrw and then will give you advise. It's 3.15 in the morning over here, so, need a little rest.

I could not get any result from entering your model in their web site but the "T Touch online" seems to be a watch that has similar features perhaps.

Their catalogues seem to be generic, so by going to their web site http://support.tissot.ch/?mod_flashPDF/id_138 you may finswhat you need.

You Can see the video in my blog how can change the battery from Tissot Sea Touch.Is all the same. www.watch4maker.com

If you take a jeweler's lupe near where the arrow is you will see the word "reset" in the plastic. There is a deep hole in the plastic with contacts below. That is the reset, and that is why you must use very sharp pointed tweezers to make contact with the back of the battery.I think if you do not have sharp tweezers, you can probably put a sewing pin down the hole, and then connect with a small screwdriver to the back of the battery

Click on my profile (escapement), then click on Tips and Tricks. There you will find link to all TISSOT watch manuals.Rate me, please

HOW TO remove/resize watch bracelets

Hi. As it would take a lot of time to write and draw all necessary figures right here, I would like to give you direct page address for all TISSOT TOUCH EXPERT settings. If the print is too small - use ZOOM tool to magnify it. Hope it will help. Follow this link: http://support.tissot.ch/usersmanual/141-en.pdf

it's not a button, it is the crown. you can pull it to adjust the time

The Tissot Touch watch is expected to need "SYNCHRONIZTION" periodically. (that is, to synchronize the digital and analog portions.) The Tissot manual tells how to do this. This manual came with your watch and is available online from the Tissot website.

good luck, Rodney

If you syncro you must touch the center until the option look open the press the middle button for 5 sec and you see the function Synchro.You must set the 2 hands at 12 exactly.greekdimis.blog spot.

If your watch is battery operated, the most common reason is battery itself. Don't mind it was bought in January, because watch itself could be in shop storage for years (even if it is one of the new models). If your watch is automatic/hand wound, then there might be a problem with movement and in this case you will need help of qualified watchmaker.

Was the battery empty in the first place, or was the watch already defect? Did you put in the correct and a new battery? or perhaps you did put n the old battery? can you measure the voltage of the batteries, to check? Just a few questions that came up with me.

Shortcut battery with AC contact. AC can be found on the sides of watch movement(very tiny). You have to use pointed tweezers: one end on battery+, another on AC contact for three secsIf you take a jeweler's lupe near where the arrow is you will see the word "reset" in the plastic. There is a deep hole in the plastic with contacts below. That is the reset, and that is why you must use very sharp pointed tweezers to make contact with the back of the battery.I think if you do not have sharp tweezers, you can probably put a sewing pin down the hole, and then connect with a small screwdriver to the back of the battery