Westinghouse Vacuums - Recent Questions, Troubleshooting & Support
How do I open the vacuum assembly?
you have to take the headlight lenses off with a small screwdriver. then a philips screwdriver to take the 2 screws out. one each side. then remove the foil shields on each headlight . then snap loose the rear plastic clips on the cover and it will come right off. it took me an hour to find out how and 10 minutes or less to take it off. watch for the micro switch on the circuit board being worn out.it will stop the roller brush from turning.its a dollar part at any good electronics store ,but will have to be soldiered in or service might have a few from the westinghouse line .so will a broken belt which is a special grooved belt available from fantom at 18007987395..
HOw do i open it to clean it? I can't find a
It is simply a hard pull out from the top of the silver container. The top will swing out and then you can take it off. I also pushed down a little bit, but I believe the main part to simply pull out. A fairly strong plastic tab holds it in place, so it took some force, but did not break anything.
Not finding what you are looking for?