Not older better.
Andrew White posted an answer for this Honda Garden:
"Not worked on too many of these, however it would suggest there is either wear in the..."
Andrew White posted an answer for this Black & Decker Garden:
"When checking for a spark you must make sure the spark plug is well earthed against the..."
Andrew White posted an answer for this John Deere Garden:
"If its an over head cam engine then yes you would have to do the valve timing, if its a..."
Andrew White posted an answer for this Husqvarna Garden:
"To get the fault codes the saw needs to be connected to CST ( common service tool ) within..."
Andrew White posted an answer for this Briggs Garden:
"The clutches are electro magnetic, so there is an electrical winding inside, once 12 volts..."
Andrew White posted an answer for this Echo Garden:
"You need three things for the engine to run, a good clean fuel supply to the piston, a..."
Andrew White posted an answer for this Husqvarna Garden:
"Its very difficult to explain exactly how the cable fits into the carb spindle however the..."
Andrew White posted an answer for this Homelite Garden:
"Chainsaw oil pumps are fairly simple affairs, to increase oil flow you obviously cannot..."
Andrew White posted an answer for this Husqvarna Garden:
"The thing to remember here is the bulb is a purge, not a primer, so it pulls fuel from the..."
Andrew White posted an answer for this Ryobi Garden:
"Stating the obvious it is running too lean on the mixture screws, you may well need a..."
Andrew White posted an answer for this Weedeater Garden:
"Anything under 100 psi after 5 good pulls would suggest it has internal damage or wear."
Andrew White posted an answer for this Husqvarna Garden:
"No, the oil pump is fixed and driven by a gear behind the sprocket, on the bottom of the..."
Andrew White posted an answer for this Husqvarna Garden:
"the roll action throttle replaced the direct wire linkage on the 181, this type of..."
Andrew White posted an answer for this Husqvarna Garden:
"there is no base setting for the carb when changing to a non standard cylinder, so as not..."
Andrew White posted an answer for this Troy Garden:
"This is because one of the blade connecting rods in the gearbox is no longer connected to..."
Andrew White posted an answer for this Cub Cadet Garden:
"most rear tine cultivators will have a chain and gear inside the gear box, so I would..."
Andrew White posted an answer for this Poulan Garden:
"Well you certainly have tried a great deal of things, your compression is fairly low,..."
Andrew White posted an answer for this Ryobi Garden:
"This is just the return to tank pipe, it does not need to be in the fuel, just in the tank..."
Andrew White posted an answer for this Husky Garden:
"The part throttle is actuated by the choke pull, the choke shaft on the carb has a white..."
Andrew White posted an answer for this Husqvarna Garden:
"There are certain things you need for it to start and run, A good spark, and at the..."
Andrew White posted an answer for this Poulan Garden:
"The ignition timing is controled by the flywheel in relation to the core of the ignition..."
Andrew White posted an answer for this Stihl Garden:
"The ignition works off speed of rotation, so you need to crank the engine well withe the..."
Andrew White posted an answer for this whipper snipper Garden:
"You should go by what the oil manufacturer says on the side of the two stroke oil bottle,..."
Andrew White posted an answer for this Craftsman Garden:
"Most transaxles will have a disc brake on the side, if the brake is binding on the disc..."
Andrew White posted an answer for this Stihl Garden:
"It is quite unusual for them to exude fuel from the carb, if somebody has removed the carb..."
Andrew White posted an answer for this Poulan Garden:
"The plug gap should be 0.5mm"
Andrew White posted an answer for this Stihl Garden:
"You seem to have done everything, you need to make sure you have a 0.3mm gap between the..."
Andrew White posted an answer for this Troy-Bilt Garden:
"The typical reason to lose oil into the filer box, is that the engine has been tipped up,..."