Hank Orsel posted an answer for this Candy Dryers:
"I expect it has 4" duct exhausting to outside? It's possibly restricted with lint, either..."
Hank Orsel posted an answer for this GE Kitchen Appliances - Others:
"If you feed single phase into the line terminals, you will get only 1/3 the heat wattage...."
Hank Orsel posted an answer for this Beko Refrigerators:
"The water is condensate from the evaporator during the defrost cycle. It normally drains..."
Hank Orsel posted an answer for this Samsung RFG297AAPN (29 cu ft) Bottom Freezer French Door Refrigerator:
"I'd pack all the frozen food (and ice cubes) in a plastic bin and wrap with blankets or..."
Hank Orsel posted an answer for this Samsung Refrigerators:
"At the back of the freezer you should find a set of screws holding the plastic panel in..."
Hank Orsel posted an answer for this Beverage-Air MT17 Refrigerator Commercial:
"Low refrigerant would make it inefficient but if it chills to 28° it can't be that bad. I..."
Hank Orsel posted an answer for this Chevrolet 2002 Chevrolet S-10 LS:
"ABS uses only brake lines. The power brake booster uses 1 vacuum line. Did you mean PCV..."
Hank Orsel posted an answer for this Heating & Cooling:
"Yes. The coil voltage, number of poles must match. And if it fits a socket, the pin..."
Hank Orsel posted an answer for this Heating & Cooling:
"Climb on the roof and look at the nameplate. It will give the FLA. (Full Load Amps)"
Hank Orsel posted an answer for this Sharp Heating & Cooling:
"Have to attach a tube tap with a schrader valve. Then can connect a set of gauges and..."
Hank Orsel posted an answer for this Samsung Heating & Cooling:
"Probably "Cooling""
Hank Orsel posted an answer for this Saturn 2007 VUE V6:
"Common problem is the fan speed resistors burning out. Then it works only on high."
Hank Orsel posted an answer for this Heating & Cooling:
"Still in Program mode?"
Hank Orsel posted an answer for this Subaru 2012 Legacy 2.5i Limited:
"You have a break in the ground (black) wire. Follow it along lighting harness and find..."
Hank Orsel posted an answer for this Heating & Cooling:
"Tried a new battery?"
Hank Orsel posted an answer for this Heating & Cooling:
"Check to see that you have proper voltage on the LOAD side of the condenser unit contactor..."
Hank Orsel posted an answer for this Heating & Cooling:
"I want 5 million dollars in cash."
Hank Orsel posted an answer for this Heating & Cooling:
"You'll need a jumper to connect the common leads to 1 side of both caps. Then put the 55..."
Hank Orsel posted an answer for this Dyson DC40 Multi-floor Vacuum DC40:
"The hose is blocked, so you have very little suction at the end. The vacuum in the hose is..."
Hank Orsel posted an answer for this Ford Cars & Trucks:
"Depends on the year. Older ones have an electric relay supplying 12v to the starter..."
Hank Orsel posted an answer for this Dyson DC14 Animal Bagless Upright Cyclonic Vacuum:
"There's a spring in the switch to give it "snap action" on or off. The spring may be..."
Hank Orsel posted an answer for this Dyson DC40 Multi-floor Vacuum DC40:
"The hose is blocked, so you have very little suction at the end. The vacuum in the hose is..."
Hank Orsel posted an answer for this kawasaki Motorcycles:
"A tiny speck of dirt blocking the low speed brass jet can do that. Remove the carb from..."
Hank Orsel posted an answer for this Power Motorcycles:
"A partially plugged exhaust will cause it to overheat and lose power. When it stalls, do..."
Hank Orsel posted an answer for this Motorcycles:
"Most bikes have it stamped on a machined spot on the cylinder somewhere. It may be hidden..."
Hank Orsel posted an answer for this Honda Garden:
"http://engines.honda.com/company/faq"
Hank Orsel posted an answer for this 1999 GMC Jimmy:
"Sounds like not enough voltage to run the ECM from your battery, (but enough to crank it..."
Hank Orsel posted an answer for this 2011 Chrysler 200:
"Chrysler fault codes; http://www.allpar.com/fix/computer-codes.html"
Hank Orsel posted an answer for this Cars & Trucks:
"The pinout of a 7 way trailer connector is at ..."