John Zeitler posted an answer for this 2004 GMC Envoy:
"Sounds a bearing noise. Have to determine we’re it’s coming from. I have seen a lot of..."
John Zeitler posted an answer for this 2001 Jeep Cherokee:
"Try and get a hold of the cable at any location , You will have to have a pair of pliars..."
John Zeitler posted an answer for this 1989 Jeep Cherokee:
"Any resent work performed ? If linkage is good I would say Internal damage inside the..."
John Zeitler posted an answer for this Jeep Cars & Trucks:
"Check the track under the seat just to make sure . Unfortunately it sounds like a gear..."
John Zeitler posted an answer for this Jeep Cars & Trucks:
"With not actually hearing or inspecting.. I would check; u- joints ,pinion bearings,fluid..."
John Zeitler posted an answer for this 2010 Chrysler Town and Country:
"try a little graphite on the cylinder and key"
John Zeitler posted an answer for this 2009 Chrysler Town and Country:
"I would try to recalibrate the climate control head"
John Zeitler posted an answer for this Chrysler Cars & Trucks:
"under the passenger side front just below the fire wall"
John Zeitler posted an answer for this 2010 Chrysler Town and Country:
"Most likely will end up being a program issue."
John Zeitler posted an answer for this 2010 Chrysler Town and Country:
"from under the front bumper facia"
John Zeitler posted an answer for this 2010 Chrysler Town and Country:
"Is the speedo working properly / if not repair the spedo. Also you can try and reset the..."
John Zeitler posted an answer for this Chrysler Cars & Trucks:
"all belts and pulley need to come off, belt and tensioner are located behind the metal..."
John Zeitler posted an answer for this 2002 Chrysler Concorde LXi:
"Manually recalibrate the control head"
John Zeitler posted an answer for this 2008 Chrysler Sebring:
"Take a close look at the shift interlock cable, can repair without removing the console..."
John Zeitler posted an answer for this 2001 Chrysler Town and Country:
"Check make sure the lock is not engaged for pass window, the drivers side switch is the..."
John Zeitler posted an answer for this Pontiac Cars & Trucks:
"IS THE SPEEDO WORKING, WONT SHIFT WITH MOUT THAT REFRENCE"
John Zeitler posted an answer for this 2003 Cadillac CTS:
"Is it the ignition key chip ? most likely will have to have it reprogramed, did you try..."
John Zeitler posted an answer for this Mercury Cars & Trucks:
"Is the speedo working properly?"
John Zeitler posted an answer for this 2005 Cadillac Deville:
"Under the center of the dash."
John Zeitler posted an answer for this 2004 Nissan Sentra:
"power distribution center under the hood."
John Zeitler posted an answer for this 1999 Chrysler LHS:
"Trans could be stuck in limp in mood, may just need to replace the speed sensor, or..."
John Zeitler posted an answer for this 2002 Jeep Liberty:
"Make sure they are simply not locked out on the switch. The drivers switch is the master..."
John Zeitler posted an answer for this 2006 Pontiac G6:
"I would take a close look at the connections in the power distribution box , also look at..."
John Zeitler posted an answer for this Cars & Trucks:
"Vehicle is most likely in " limp" in mode and needs to go to the dealer to be diagnosed...."
John Zeitler posted an answer for this 1997 Ford Taurus:
"Place a floor jack under the vehicle apply slight pressure remove mounting bolts jack..."
John Zeitler posted an answer for this 2000 Ford Taurus:
"yes"
John Zeitler posted an answer for this 2005 Ford Taurus:
"Try unlocking and locking the drivers door with the key, will most likely reset the theft..."
John Zeitler posted an answer for this 2001 Ford Taurus:
"I would check the connection in the power distribution box under the. you will see the..."
John Zeitler posted an answer for this Cars & Trucks:
"That is indicating a fault code. Need to have diagnostic codes retrieved and necessary..."
John Zeitler posted an answer for this 2004 GMC Sierra:
"Sounds like a blown fuse, check all fuses"
John Zeitler posted an answer for this 2004 Jeep Grand Cherokee:
"Are all other gauges working, if not check fuses , all good and getting power, take a look..."