3Wireless Systems and radios: on site specialist
John L radiodude365 posted an answer for this Kaito KA500 AMFMWeather Radio:
"is this the kato voyager emergency radio? I'll assume it is. New or used? If new, return..."
John L radiodude365
John L radiodude365 posted an answer for this Radio Communications:
"Your Kenwood radio has programmable squelch. It is accessible through the software...."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"I did a lot of digging around. Your FT-301 is a nice radio. However the service manual..."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"Even saying ICOM would help people to help you. That radio requires software and a..."
John L radiodude365John L radiodude365 posted an answer for this Parrot Radio Communications:
"wrong category. try cell phones or bluetooth. This is radio communications."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"Make certain the AM/FM radio is off. You cannot squelch when it is on. Try adjusting..."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"go to cellphones. This is radio communications"
John L radiodude365John L radiodude365 posted an answer for this Motorola Radio Communications:
"It requires the radio programming program. You must take it to a dealer. It will cost a..."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"Your antenna should not make any difference with power or receiving. Is the scanner mobile..."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"Radio frequencies are different from country to country. NZ will use different frequencies..."
John L radiodude365John L radiodude365 posted an answer for this Cobra Radio Communications:
"That's a confusing question. Device id is the FCC device ID number and means it has been..."
John L radiodude365John L radiodude365 posted an answer for this Radio Shack Radio Communications:
"The scanner has a squelch knob, so it sounds like the squelch switch is broken or full of..."
John L radiodude365John L radiodude365 posted an answer for this Kenwood Radio Communications:
"It may be an out of market radio, meaning from another country. Most cannot be programmed..."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"It is an OLD scanner. New digital frequencies are not available to this scanner. The good..."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"Typically you press the button on the front that is marked T/A. It means "talk around" or..."
John L radiodude365John L radiodude365 posted an answer for this Vertex Radio Communications:
"The new radios not being able to be programmed from the "old" ones often happens. The new..."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"Your question is not very specific. Do you have a programming cable? Can you access the..."
John L radiodude365John L radiodude365 posted an answer for this BellSouth Radio Communications:
"Bellsouth does not sell parts. You likely could buy a used one on eBay or buy new radios."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"It obviously works, so it is NOT a fuse. The most likely cause is a poor antenna..."
John L radiodude365John L radiodude365 posted an answer for this BellSouth Radio Communications:
"If you can do minor soldering, you may be able to fix the radio. They have no parts..."
John L radiodude365John L radiodude365 posted an answer for this Midland Radio Communications:
"Yes. They call it silent operation. To set SILENT OPERATION, press the MENU button until..."
John L radiodude365John L radiodude365 posted an answer for this Motorola Radio Communications:
"I will check on the "dial tone". The Z under MON means to scan. You hold it down about 2..."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"The speaker does not mute. It is most likely a programming issue or a channel issue. Since..."
John L radiodude365John L radiodude365 posted an answer for this Cobra Radio Communications:
"It is a radar detector, not a radio. You are in the wrong area. I honestly cannot figure..."
John L radiodude365John L radiodude365 posted an answer for this Uniden Radio Communications:
"Often I found a scanner needed all the positions to be filled. My older Bearcat did. For..."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"You need to find your local Ham radio club. Ask politely, they have this information, but..."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"If they are charged, be certain to hold the power switch down at least 0.5 second. Have..."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"Not certain I understand the bench issue. If your phone, whether cell or cordless has..."
John L radiodude365John L radiodude365 posted an answer for this Radio Communications:
"Have you checked the receive tone on the repeater channel? Check the receive frequency..."
John L radiodude365
John L radiodude365 posted an answer for this Health & Beauty:
"When mine is high, I get headaches. I also fatigue quicker and get irritable. There is no..."
John L radiodude365
John L radiodude365 posted an answer for this Alfa Cars & Trucks:
"It says you have a Cummins 400 hp Diesel motor. Looks like 15w 40. Double check this..."
John L radiodude365
Radio Communications 525 answers
Lands Phones 14 answers
Cars & Trucks 7 answers Cell Phones 3 answers
Televison & Video 1 answer
Computers & Internet 1 answer
Health & Beauty 1 answer
Audio Players & Recorders 1 answer
