Peter Hall posted an answer for this Welding Tools:
"If water gets into electrical equipment the big danger comes from current flowing through..."
Peter Hall posted an answer for this Jeep Cars & Trucks:
"You need to read the fault codes to point you at the fault. Can be caused by quite a lot..."
Peter Hall posted an answer for this The Computers & Internet:
"Seems likely the battery has become disconnected or has completely failed. It's not common..."
Peter Hall posted an answer for this The Audio Players & Recorders:
"This is normally fed with preamp-out signal level (line level, approx 0.7V audio signal,..."
Peter Hall posted an answer for this Roland Music:
"It's usually fine to leave solid state electronic equipment turned on. A small amount of..."
Peter Hall posted an answer for this Televison & Video:
"You don't give any details of the make/model so this is just a guess.
The backlight on..."
Peter Hall posted an answer for this Sharp Computers & Internet:
"ERR80 indicates a problem reading valid data from the EEPROM at power-on ("Protect area..."
Peter Hall posted an answer for this Cars & Trucks:
"There are quite a few possible reasons for low power, including failing spark plugs or..."
Peter Hall posted an answer for this Cars & Trucks:
"Nice bike!
Likely to be one of the following:
Spark plugs can fail totally open..."
Peter Hall posted an answer for this Cars & Trucks:
"Check the temperature switch that controls the fans and the fan relays (occasionally..."
Peter Hall posted an answer for this Kitchen Ranges:
"Make sure that you have isolated the unit from the power before touching any wires or..."
Peter Hall posted an answer for this Dodge Cars & Trucks:
"If you get a single loud click when you turn the key to start then it's likely to be a..."
Peter Hall posted an answer for this Sansui Audio Players & Recorders:
"Sad to say it's likely to be 1 or more transistors in the power amp circuit, although..."
Peter Hall posted an answer for this Miscellaneous:
"I think it's a magneto ignition which means it should spark unless the (white ?) wire..."
Peter Hall posted an answer for this Sewing Machines:
"Double check that bobbin thread is correctly threaded through its tensioning path. If it..."
Peter Hall posted an answer for this Bunn Coffee Makers & Espresso Machines:
"This sounds like the light flickering rather than a faulty connection. You can check for a..."
Peter Hall posted an answer for this Cars & Trucks:
"There are a lot of things that can cause this, (e.g. crank sensor, coil, cam sensor, ECU,..."
Peter Hall posted an answer for this Building Materials:
"It's likely that the voltage supplied to the bulb is a bit high which will make the light..."
Peter Hall posted an answer for this Miscellaneous:
"Sometimes "intelligent" chargers will not start charging if a battery is too flat, but..."
Peter Hall posted an answer for this Toyota Cars & Trucks:
"Try shorting the oil pressure switch to earth (i.e. to battery -ve). I think these motors..."
Peter Hall posted an answer for this Honda Cars & Trucks:
"Check the power window switches. Both positive and negative power pass through both the..."
Peter Hall posted an answer for this Maytag Dryers:
"Green with a yellow stripe is used as European Standard wire colour for earth (i.e...."
Peter Hall posted an answer for this Televison & Video:
"The power outage is unlikely to have affected the remote but may have affected the tv. Try..."
Peter Hall posted an answer for this Cars & Trucks:
"The clear finish is not likely to hide the overlaps so another colour coat first is..."
Peter Hall posted an answer for this Sewing Machines:
"Yes it usually is caused by lack of bobbin tension. The bobbin tension doesn't usually..."
Peter Hall posted an answer for this Icom Radio Communications:
"Sure sounds like a "low volts" reboot due to high current draw. Are you measuring..."
Peter Hall posted an answer for this Cars & Trucks:
"This question is listed under Cars and Trucks but if it's 3/4 hp then I think it's..."