Press enter to search.
a 30 yeay tech
quennie732 posted an answer for this Ricoh Aficio 1035 Copier:
"Left lower front open door small near the floor, pull out used toner cart."
quennie732 posted an answer for this Ricoh Office Equipment & Supplies:
"High Temperature Error - Software (Fatal Error) The temperature inside the fusing unit..."
"You have a "baked toner" on the mag rool in developer assy, should look shiny, clean off..."
"You have a bad black toner pump. p/n D0293221"
"Mag roll in developer assy gets "baked toner " on it remove and clean."
"enter service mode, cycle power (push in sequence clear modes, 1, 0, 7, hold the stop..."
"clean the white plate (underside of orig. glass"
"Laser slat dirty. -Carl"
"IH unit bad, this is an old unsupported Ricoh unit sorry.- Carl"
"Developer assy locked up, its the lower part of the drum assy. Open right door turn gray..."
"Bad hard drive? unplug it an turn on unit. -Carl"
"If you go into "user tools" is there a printer and scanner option there? If not the MFD..."
"Make sure the fuser handles are down fully"
"Engine startup error - sudden communication reset between controller and..."
quennie732 posted an answer for this Ricoh Aficio™ SP-C210SF Printer:
"Enter service mode, Counting method SP5-045-001 Specifies if the counting method used in..."
quennie732 posted an answer for this Ricoh 406962 aficio sp 3510dn 28ppm mono laserpr:
"Order and replace print cartridge."
"install another print driver.- Carl"
"No password at default is needed. -Carl"
quennie732 posted an answer for this Ricoh SP 8100DN Aficio Laser Printer:
"on the door, a green lever on front lift to "up" and remove. -Carl"
quennie732 posted an answer for this Ricoh Aficio 1515MF All-In-One Laser Printer:
"Not enough info, does it make a loud grind noise that stops if you push on the left door,..."
"on the plate on rear cover, sometimes low. -Carl"
"Enter service mode (hold up and down arrows "down" for 6 or so seconds release and press #..."
"Clear modes(yellow) 1 0 7 hold clear/stop for 5 seconds, and reset the web counter. -Carl"
quennie732 posted an answer for this Ricoh Aficio SP C411DN Laser Printer:
"Sounds like the black drum unit, but could be dust on the laser glass. -Carl"
"you have to reset the fuser error with SP 5-810, hold down the up and down arrows for 6 or..."
quennie732 posted an answer for this Office Equipment & Supplies:
Trans/development motor error - check for binding/overload on motor"
"Push in order Clear modes (yellow) 1 0 7 then press and hold stop till screen changes...."
quennie732 posted an answer for this HP Office Equipment & Supplies:
"Yes of course, I prefer the 4*** series, for the best ease of use and productive output...."
Load more activity...
185,796 people helped
View all achievements